Nissan Murano: Mirrors :: Removal and Installation / Door Mirror Actuator
Removal and Installation
REMOVAL
Remove door mirror glass. Refer to Removal and Installation.
Remove screw (A) from door mirror actuator (1).

Disconnect harness connector from door mirror actuator and remove.
INSTALLATION
Installation is in the reverse order of removal.
Removal and Installation
REMOVALRemove door mirror glass. Refer to Removal and Installation.
Release pawls using a suitable tool and remove door mirror rear finisher...
Removal and Installation
The side camera finisher (if equipped) is serviced as part of the door mirror rear finisher. Refer to Removal and Installation...
Other information:
DTC Description
DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC Detection Condition
B2195
ANTI-SCANNING
(Anti-scanning)
Diagnosis condition
When ignition switch ON.
Signal (terminal)
—
Threshold
ID verification between BCM and ECM that is out of the designated specification is detected
Diagnosis delay time
—
POSSIBLE CAUSEID verification request out of the designated specificationFAIL-SAFEInhibit engine cranking
DTC Confirmation Procedure
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
Ignition switch ON...
DTC Description
DESCRIPTIONDTC B00A0 OCCUPANT CLASSIFICATION SYSTEM (OCS)The OCS control unit is wired to the air bag diagnosis sensor unit. The air bag diagnosis sensor unit will monitor the OCS for failures and interruptions in communication between the OCS control unit and the air bag diagnosis sensor unit...