Nissan Murano: Mirrors :: Removal and Installation / Door Mirror Glass
Removal and Installation
REMOVAL
Apply protective tape to door mirror.
Release metal clips and pawls that retain door mirror glass using a suitable tool, disconnect harness connectors (A)(if equipped) from door mirror glass and remove.

: Metal clip
: Pawl
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
After installation, visually inspect that metal clips and pawls are securely engaged.
Exploded View
1.
Door mirror glass
2.
Door mirror actuator
3.
Side camera (if equipped)
4.
Door mirror
5.
Door mirror rear finisher
6...
Removal and Installation
REMOVALRemove door mirror glass. Refer to Removal and Installation.
Release pawls using a suitable tool and remove door mirror rear finisher...
Other information:
Component Parts Location
No. Component Function
1.
Rear seat belt buckle switch RH & CTR
Transmits the rear seat belt buckle switch RH & CTR signal to the air bag diagnosis sensor unit.
2.
Front seat belt buckle switch RH
Transmits the front seat belt buckle switch RH signal to the combination meter...
DTC Description
DTC DETECTION LOGIC
ECM back up system does not function properly.
EEPROM (built-in microcomputer) system internal ECM does not function properly.
DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P0603
ECM BACK UP/CIRCUIT
[Internal Control Module Keep Alive Memory (KAM) Error]
Diagnosis condition
Ignition switch ON
Signal (terminal)
—
Threshold
ECM back up system does not function properly
Diagnosis delay time
—
P062F
CONTROL MODULE
(Internal control module EEPROM error)
Diagnosis condition
Start engine and let it idle
Signal (terminal)
—
Threshold
EEPROM (built-in microcomputer) system internal ECM does not function properly
Diagnosis delay time
—
POSSIBLE CAUSEDTC P0603
Harness or connectors
[ECM power supply circuit is open or shorted...