Nissan Murano: Symptom Diagnosis / Does Not Operate

Nissan Murano (Z52) 2015-2024 Service Manual / Brakes / Brake Control System :: Vdc/tcs/abs / Symptom Diagnosis / Does Not Operate

Diagnosis Procedure

VDC function, TCS function, ABS function, EBD function, brake assist function or hill start assist function does not operate.

CAUTION:

  • VDC function, TCS function, ABS function, EBD function, brake assist function and hill start assist function never operate when the Nissan Murano vehicle speed is 6.2 MPH (10 km/h) or less. However, TCS function and hill start assist function operate when the Nissan Murano vehicle speed is 0 MPH (0 km/h) (the vehicle is in stop status).

  • VDC function and TCS function never operate when VDC OFF switch is operated (when VDC OFF indicator lamp turns ON).

CHECK ABS WARNING LAMP

Check that ABS warning lamp, brake warning lamp and VDC warning lamp turn ON and turn OFF approximately 1 second after key switch is turned ON. Check that ABS warning lamp, brake warning lamp and VDC warning lamp stay in OFF status during driving.

CAUTION:

Brake warning lamp turns ON when parking brake is operated (parking brake switch is ON) or brake fluid is less than the specified level (brake fluid level switch is ON).

Is the inspection result normal?

YES>>

Normal

NO>>

GO TO 2.

PERFORM SELF DIAGNOSTIC RESULT

CONSULT

  1. Ignition switch OFF → ON.

    CAUTION:

    • Be sure to wait 10 seconds after ignition switch OFF or ON.

    • Start the engine.

  2. Repeat step 1 two or more times.

  3. Select “Self Diagnostic Result” mode of “ABS”.

Is any DTC detected?

YES>>

Check the DTC. Refer to DTC Index.

NO>>

Inspection End.

    The Braking Distance Is Long

    Diagnosis Procedure Brake stopping distance is long when ABS function is operated.CAUTION: Brake stopping distance on a slippery road like a rough road, gravel road or snowy road may become longer when ABS is operated than when ABS is not operated...

    Brake Pedal Vibration or Operation Sound Occurs

    Diagnosis Procedure Brake pedal vibrates and motor sound from ABS actuator and electric unit (control unit) occurs when the engine starts. Brake pedal vibrates during braking...

    Other information:

    Nissan Murano (Z52) 2015-2024 Service Manual: Warning System Chime Does Not Sound


    Diagnosis Procedure Symptom check: In the following conditions, the warning system chime may not sound even if the vehicle distance is short. When the vehicles are traveling at the same speed and the distance between vehicles is not changing. When the Nissan Murano vehicle ahead is traveling faster and the distance between vehicles is increasing...

    Nissan Murano (Z52) 2015-2024 Owners Manual: Instrument panel


    Vent Headlight/fog light (if so equipped)/turn signal switch Supplemental air bagHorn Meters and gaugesWarning and indicator lights Vehicle information display Wiper and washer switchRear window wiper and washer switch Audio system/Center display controls Hazard warning flasher switch Center displayNavigation display (if so equipped) Front passenger supplemental air bag Glove box Passenger supplemental knee air bag Front passenger air bag status light Power outlet USB portsAUX jack Heater and air conditioning controls Shift lever Push-button ignition switch Cruise control switches (if so equipped)Intelligent Cruise Control (ICC) switches (if so equipped) Driver supplemental knee air bag Bluetooth® Hands-Free Phone System/Audio control switches Hood releaseFuel door release Fuse box Heated steering wheel switch (if so equipped)Dynamic driver assistance switch (if so equipped) Liftgate instrument panel switch (if so equipped) 24...

    Categories

    LATCH (Lower Anchors and Tethers for CHildren) system

    Nissan Murano. LATCH (Lower Anchors and Tethers for CHildren) system

    LATCH system lower anchor locations - bench seat

    Your vehicle is equipped with special anchor points that are used with LATCH system compatible child restraints. This system may also be referred to as the ISOFIX or ISOFIX compatible system. With this system, you do not have to use a vehicle seat belt to secure the child restraint unless the combined weight of the child and child restraint exceeds 65 lbs. (29.5 kg). If the combined weight of the child and child restraint is greater than 65 lbs. (29.5 kg), use the vehicle’s seat belt (not the lower anchors) to install the child restraint. Be sure to follow the child restraint manufacturer’s instructions for installation.

    read more

     
    Copyright © 2026 www.nimurano.com