Nissan Murano: Lane Camera (lane Camera Unit) / C1b0a-16 Power Supply Circuit2

Nissan Murano (Z52) 2015-2024 Service Manual / Cruise Control & Driver Assistance / Driver Assistance System :: Driver Assistance System / Dtc/circuit Diagnosis / Lane Camera (lane Camera Unit) / C1b0a-16 Power Supply Circuit2

DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
C1B0A-16

POWER SUPPLY CIRCUIT2

(Power supply circuit) 		Diagnosis condition When ignition switch is ON.
Signal (terminal) -
Threshold Lane camera unit ignition voltage is less than 10.5V.
Diagnosis delay time 5 seconds or more.

POSSIBLE CAUSE

  • Harness, connector or fuse

  • Lane camera unit

  • Power supply circuit

FAIL-SAFE

The following functions are suspended:

  • Lane Departure Warning (LDW)

  • Intelligent Lane Intervention (I-LI)

  • Automatic Emergency Braking (AEB) with pedestrian detection

  • Automatic Emergency Braking (AEB)

  • Rear Automatic Braking (RAB)

  • Traffic Sign Recognition (TSR)

Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Start the engine.

  2. Perform “All DTC Reading”.

  3. Check if “C1B0A-16” is detected as the current malfunction on the “Self Diagnostic Result” of “LANE CAMERA”.

Is “C1B0A-16” detected as the current malfunction?

YES>>

Refer to DTC Diagnosis Procedure.

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

CHECK LANE CAMERA UNIT SUPPLY AND GROUND CIRCUIT

Check power supply and ground circuit of lane camera unit. Refer to Diagnosis Procedure.

Is the inspection result normal?

YES>>

Replace the lane camera unit. Refer to Removal and Installation.

NO>>

Repair or replace harness or connectors.

    C1b00-4b Camera Unit Malf

    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition C1B00-4B CAMERA UNIT MALF (Camera unit malfunction) Diagnosis condition When ignition switch is ON...

    U0104-00 Adas Can 1

    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition   U0104-00 ADAS CAN CIRC 1 (ADAS control unit CAN circuit 1) Diagnosis condition When ignition switch is ON...

    Other information:

    Nissan Murano (Z52) 2015-2024 Service Manual: Steering Switch


    Diagnosis Procedure CHECK STEERING SWITCH CIRCUIT Ignition switch OFF. Disconnect combination meter harness connector and spiral cable harness connector. Check continuity between combination meter harness connector and spiral cable harness connector...

    Nissan Murano (Z52) 2015-2024 Service Manual: Bose Speaker Amp


    Reference Value TERMINAL LAYOUTPHYSICAL VALUES Terminal (Wire color) Description Condition Reference value (Approx.) + – Signal name Input/Output 1 (W) 2 (V/G) Instrument panel tweeter LH Output Ignition switch ON Sound output 4 (W) 3 (G) Instrument panel tweeter RH Output Ignition switch ON Sound output 5 (W) 6 (B) Sound signal subwoofer Output Ignition switch ON Sound output 7 (GR) — Ground — Ignition switch ON 0 V 10 (SB) 7 (GR) Battery power supply Input Ignition switch OFF Battery voltage 11 (G) 7 (GR) Battery power supply Input Ignition switch OFF Battery voltage 12 (B) — Ground — Ignition switch ON 0 V 13 (W) 8 (B) Sound signal subwoofer Output Ignition switch ON Sound output 14 (R) 9 (P) Sound signal rear door speaker RH Output Ignition switch ON Sound output 18 (V/R) 19 (O) Sound signal front door speaker and tweeter LH Output Ignition switch ON Sound output 20 (W) Ground Amp...

    Categories

    read more

     
    Copyright © 2026 www.nimurano.com