Nissan Murano: Basic Inspection / Configuration (audio Unit)

Description

Vehicle specification needs to be written with CONSULT because it is not written after replacing audio unit.

Configuration has three functions as follows:

CAUTION:

• When replacing audio unit, you must perform “Select Saved Data List” or "After Replace ECU" with CONSULT.

• Complete the procedure of “Select Saved Data List” or "After Replace ECU" in order.

• If you set incorrect “Select Saved Data List” or "After Replace ECU", incidents might occur.

• Configuration is different for each Nissan Murano vehicle model. Confirm configuration of each vehicle model.

• Never perform “Select Saved Data List” or "After Replace ECU" except for new audio unit.

WRITING MODE SELECTION

CONSULT Configuration

Select “Re/programming, Configuration” of "MULTI AV".

GO TO 2.

GO TO 3.

WRITING Nissan Murano Vehicle SPECIFICATION

CONSULT Configuration

Select “Configuration” or “After Replace ECU”, and write the Nissan Murano vehicle specification saved in CONSULT to audio unit.

CAUTION:

Do not perform any operation such as the navigation operation during configuration writing.

GO TO 4.

WRITE Nissan Murano Vehicle SPECIFICATION

CONSULT Configuration

1. Select “Re/programming, Configuration” of "MULTI AV".

2. Select “Manual Configuration”, and write the setting value as shown in the following table to audio unit according to the Nissan Murano vehicle specification.

   CAUTION:

   Grasp vehicle specifications precisely. The control of ECU control may not function normally if the specifications are misread.

   NOTE:

   • The items shown in the list depend on Nissan Murano vehicle specifications.

   • The config list may not be displayed depending on vehicle specifications. This is not a malfunction.

   • If selection items are not displayed on the CONSULT screen, touch "NEXT".

   MANUAL SETTING ITEM		Detail
   Items	Setting value
   NAVIGATION	WITH	Models with navigation system
   	WITHOUT	Models without navigation system
   SOUND SYSTEM	BOSE	Models with Bose audio
   	NORMAL 6SPKS	Models without Bose audio
   CAMERA SYSTEM	NONE or AVM ph3	Models with Intelligent around view monitor system
   	REAR	Models with rear view monitor system
   SONAR TYPE	None	Models without sonar
   	REAR	Models with sonar
   PREDICTIVE COURSE LINE	Without or with (with AVM)	Models with Intelligent around view monitor or without camera
   	With (Rear view camera)	Models with rear view monitor

GO TO 4.

PERFORM SELF-DIAGNOSIS

CONSULT Self Diagnostic Result

Perform self-diagnosis of CONSULT, and check whether or not DTC B1341–55 is detected.

Is DTC B1341–55 detected?

GO TO 1.

GO TO 5.

OPERATION CHECK

Check that the operation of the audio unit and camera images (fixed guide lines and predictive course lines) are normal.

Work End.