Nissan Murano: Dtc/circuit Diagnosis / U0428 Steering Angle Sensor
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | |
|---|---|---|---|
| U0428 |
ST ANGLE SENSOR CALIBRATION (Steering angle sensor calibration) |
Diagnosis condition | When ignition switch is ON |
| Signal (terminal) | — | ||
| Threshold | — | ||
| Diagnosis delay time | — | ||
POSSIBLE CAUSE
-
Neutral position adjustment of steering angle sensor is not complete
-
Steering angle sensor
FAIL-SAFE
-
Predicted course line is not displayed
-
MOD (Moving Object Detection) function is stopped
CHECK DTC PRIORITY
If DTC U0428 is displayed with DTC U1232, first perform the diagnosis for DTC U1232.
Is DTC U1232 detected?
YES>>Proceed to DTC Description.
NO>>GO TO 2.
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
-
Ignition switch ON.
-
Select “Self Diagnostic Result” mode of “AVM” using.
-
Check DTC.
Is DTC U0428 detected?
YES>>Proceed to DTC Diagnosis Procedure.
NO>>To check malfunction symptom before repair: Intermittent Incident.
NO>>Confirmation after repair: Inspection End.
ADJUST THE NEUTRAL POSITION OF THE STEERING ANGLE SENSOR
When U0428 is detected, adjust the neutral position of the steering angle sensor.
Adjust the steering angle sensor neutral position on ABS actuator and electrical unit (control unit) side. Refer to Work Procedure or Work Procedure.
>>
GO TO 2.
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
-
Ignition switch ON.
-
Erase DTC.
-
Select “Self Diagnostic Result” mode of “AVM”.
-
Check DTC.
Is DTC U0428 detected?
YES>>Replace steering angle sensor. Refer to Removal and Installation or Removal and Installation.
NO>>Inspection End.
U1000 Can Comm Circuit
DTC Description
DESCRIPTIONCAN (Controller Area Network) is a serial communication line for real-time application. It is an on-Nissan Murano vehicle multiplex communication line with high data communication speed and excellent error detection ability...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Remote Keyless Entry Receiver
Component Function Check CHECK FUNCTION CONSULT Select “RKE OPE COUN1” in “Data Monitor” mode of “BCM(INTELLIGENT KEY)”. Check that the function operates normally according to the following conditions: Monitor Item Condition RKE OPE COUN1 Checks whether value changes when operating Intelligent Key...
Nissan Murano (Z52) 2015-2024 Service Manual: Transaxle Side
Removal and Installation REMOVALRemove drive shaft. Refer to Removal and Installation (LH) (LH) or Removal and Installation (RH) (RH). Secure front drive shaft in a vise. CAUTION: When securing shaft in a vise, always use copper or aluminum plates between vise and shaft...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Indicator lights
- GAS STATION INFORMATION
- Jacking up vehicle and removing the damaged tire
- New on site
- Most important about car
Front manual seat adjustment (if so equipped)
Your vehicle seats can be adjusted manually. For additional information about adjusting the seats, refer to the steps outlined in this section.
Forward and backward
