Nissan Murano: Side Radar (rear Right) (side Radar Rh) / C1b50-49 Side Radar Malfunction
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | |
|---|---|---|---|
| C1B50-49 |
SIDE RDR MALFUNCTION (Side radar malfunction) |
Diagnosis condition | When ignition switch is ON. |
| Signal (terminal) | – | ||
| Threshold | Side radar malfunction | ||
| Diagnosis delay time | – | ||
POSSIBLE CAUSE
Side radar RH
FAIL-SAFE
The following systems are canceled:
-
Blind Spot Warning (BSW)
-
Rear Cross Traffic Alert (RCTA)
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
-
Start the engine.
-
Select “All DTC Reading” mode.
-
Check if “C1B50-49” is detected as the current malfunction in “Self Diagnostic Result” mode of “Side radar (Rear right)”.
Is the “C1B50-49” detected as the current malfunction?
YES>>Refer to Diagnosis Procedure.
NO>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO>>Confirmation after repair: Inspection End.
PERFORM SELF DIAGNOSTIC RESULT
CONSULT
-
Turn ignition switch ON.
-
Select “Self Diagnostic Result” mode of “Side radar (Rear right)”.
-
Select “ERASE”.
-
Turn ignition switch OFF.
-
Turn ignition switch ON.
-
Check if any DTC other than “C1B50-49” is detected in “Self Diagnostic Result” mode of “Side radar (Rear right)”.
Is any DTC detected?
YES>>Perform diagnosis on the detected DTC and repair or replace the malfunctioning part. Refer to DTC Index.
NO>>Replace side radar RH. Refer to Removal and Installation.
C1b51-16 Blind Spot Warning Indicator Short Circuit
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
C1B51-16
BSW/BSI IND SHORT CIR
(Blind Spot Warning indicator short circuit)
Diagnosis condition
When ignition switch is ON...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: U1232 Steering Angle Sensor
DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U1232 ST ANGLE SEN CALIB (Steering angle sensor calibration) Diagnosis condition When ignition switch is ON Signal (terminal) — Threshold — Diagnosis delay time — POSSIBLE CAUSE Neutral position adjustment of the steering angle sensor is incomplete Steering angle sensor FAIL-SAFEPredictive course line is not displayed DTC Confirmation Procedure PERFORM DTC CONFIRMATION PROCEDURE CONSULT Ignition switch ON...
Nissan Murano (Z52) 2015-2024 Service Manual: Ecu Diagnosis Information. Abs Actuator and Electric Unit (control Unit)
Values on the Diagnosis Tool CAUTION: The display shows the control unit calculation data, so a normal value might be displayed even in the event the output circuit (harness) is open or short-circuited. Monitor item Display content Data monitor Condition Reference value in normal operation FR LH SENSOR Wheel speed 0 [km/h, mph] Nissan Murano Vehicle stopped Nearly matches the speed meter display (± 10% or less) Nissan Murano Vehicle running (Note 1) FR RH SENSOR Wheel speed 0 [km/h, mph] Nissan Murano Vehicle stopped Nearly matches the speed meter display (± 10% or less) Nissan Murano Vehicle running (Note 1) RR LH SENSOR Wheel speed 0 [km/h, mph] Nissan Murano Vehicle stopped Nearly matches the speed meter display (± 10% or less) Nissan Murano Vehicle running (Note 1) RR RH SENSOR Wheel speed 0 [km/h, mph] Nissan Murano Vehicle stopped Nearly matches the speed meter display (± 10% or less) Nissan Murano Vehicle running (Note 1) DECEL G-SEN Longitudinal acceleration detected by decel G sensor Nissan Murano Vehicle stopped Approx...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- GAS STATION INFORMATION
- Tire rotation
- Checking engine oil level
- New on site
- Most important about car
Autolight system
The autolight system allows the headlights to turn on and off automatically. The autolight system can:
Turn on the headlights, front parking, tail, license plate and instrument panel lights automatically when it is dark. Turn off all the lights (except daylight running lights) when it is light. Keep all the lights on for a period of time after you place the ignition switch in the OFF position and all doors are closed.