Nissan Murano: Dtc/circuit Diagnosis / B1383 Incomp Steering Angle Sensor Adjust
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | |
|---|---|---|---|
| B1383–01 |
Incomp steering angle senor adjust (Steering angle sensor calibration) |
Diagnosis condition | When ignition switch is ON. |
| Signal (terminal) | — | ||
| Threshold | — | ||
| Diagnosis delay time | — | ||
POSSIBLE CAUSE
-
Neutral position adjustment of the steering angle sensor is incomplete
-
Steering angle sensor
FAIL-SAFE
Predictive course line is not displayed
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
-
Ignition switch ON.
-
Ignition switch OFF and wait at least 30 seconds.
-
Ignition switch ON and wait at least 30 seconds or more.
-
Select “Self Diagnostic Result” mode of “MULTI AV”.
-
Check DTC.
Is DTC B1383 detected?
YES>>Proceed to DTC Diagnosis Procedure.
NO>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO>>Confirmation after repair: Inspection End.
ADJUST NEUTRAL POSITION OF STEERING ANGLE SENSOR
Adjusts the steering angle sensor neutral position on ABS actuator and electrical unit (control unit) side. Refer to Work Procedure.
NOTE:
When B1383 is detected, adjust the predictive course line center position of the steering angle sensor.
>>
GO TO 2.
PERFORM DTC CONFIRMATION PROCEDURE AGAIN
Perform DTC confirmation procedure again. Refer to DTC Confirmation Procedure.
Is DTC B1383 detected again?
YES>>Replace steering angle sensor. Refer to Removal and Installation.
NO>>Inspection End.
B1360 Combination Meter
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
B1360–02
Combination meter
(Combination meter connection error)
Diagnosis condition
When ignition switch is ON...
B13cf Buttons
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
B13CF-73
Buttons
(Audio unit)
Diagnosis condition
When ignition switch is ON...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Steering Gear and Linkage
Inspection BOOTCheck boot for cracks. Replace if any damage is found.OUTER SOCKET AND INNER SOCKET Ball joint swinging torque Hook the Tool at the measuring point and pull the Tool. Make sure that the Tool reads the specified value when ball stud and inner socket start to move...
Nissan Murano (Z52) 2015-2024 Service Manual: Shift Lock System
System Description The shift selector lever cannot be shifted from the “P” position unless the brake pedal is depressed while the ignition switch is set to ON. The shift lock is unlocked by turning the shift lock solenoid ON when the ignition switch is set to ON, the park position switch is turned ON (shift selector lever is in “P” position), and the stop lamp switch is turned ON (brake pedal is depressed) as shown in the operation chart in the figure...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Vehicle Dynamic Control (VDC) OFF switch
- Warning lights
- Intelligent Forward Collision Warning (I-FCW)
- New on site
- Most important about car
Vehicle security system
Your vehicle has two types of security systems:
Vehicle security system NISSAN Vehicle Immobilizer SystemThe vehicle security system provides visual and audible alarm signals if someone opens the doors, liftgate or the hood when the system is armed. It is not, however, a motion detection type system that activates when a vehicle is moved or when a vibration occurs.
