Nissan Murano: Dtc/circuit Diagnosis / B13cf Buttons
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | |
|---|---|---|---|
| B13CF-73 |
Buttons (Audio unit) |
Diagnosis condition | When ignition switch is ON. |
| Signal (terminal) | — | ||
| Threshold | — | ||
| Diagnosis delay time | — | ||
POSSIBLE CAUSE
Audio unit
FAIL-SAFE
Audio unit buttons error
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
-
Ignition switch ON.
-
Ignition switch OFF and wait at least 30 seconds.
-
Ignition switch ON and wait at least 30 seconds or more.
-
Select “Self Diagnostic Result” mode of “MULTI AV”.
-
Check DTC.
Is DTC B13CF detected?
YES>>Proceed to DTC Diagnosis Procedure.
NO>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO>>Confirmation after repair: Inspection End.
PERFORM DTC CONFIRMATION PROCEDURE AGAIN
CONSULT
-
Ignition switch ON.
-
Erase DTC.
-
Perform DTC confirmation procedure again. Refer to Confirmation Procedure.
Is DTC B13CF detected again?
YES>>Replace audio unit. Refer to Removal and Installation.
NO>>Inspection End.
B1383 Incomp Steering Angle Sensor Adjust
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
B1383–01
Incomp steering angle senor adjust
(Steering angle sensor calibration)
Diagnosis condition
When ignition switch is ON...
U1000 Can Comm Circuit
DTC Description
DESCRIPTIONCAN (Controller Area Network) is a serial communication line for real-time application. It is an on-Nissan Murano vehicle multiplex communication line with high data communication speed and excellent error detection ability...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: System Settings Cannot Be Turned On/off
Diagnosis Procedure System setting is not selectable on the combination meter. Intelligent Forward Collision Warning (I-FCW) Intelligent Drive Alertness (I-DA) Traffic Sign Recognition (TSR) Rear Automatic Braking (RAB) Lane Departure Warning (LDW) Blind Spot Warning (BSW) Intelligent Lane Intervention (I-LI) Rear Cross Traffic Alert (RCTA) NOTE: When the ignition switch is in ACC position, each system settings cannot be changed...
Nissan Murano (Z52) 2015-2024 Service Manual: System Setting
Description The settings of the automatic drive positioner system can be changed using CONSULT, the display unit in the center of the instrument panel and the set switch. Always check the settings before and after disconnecting the battery terminal or replacing driver seat control unit...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Rear bench seat adjustment
- All-Wheel Drive (AWD) (if so equipped)
- Checking engine oil level
- New on site
- Most important about car
