Nissan Murano: Removal and Installation / Av Control Unit
| 1. | AV control unit bracket (RH) | 2. | AV control unit | 3. | AV control unit bracket (LH) |
| 4. | A/C auto amp. |
REMOVAL
CAUTION:
Before disconnecting the AV control unit and battery terminals, turn the ignition switch OFF and wait at least 30 seconds.
NOTE:
-
Before replacing AV control unit, perform “Before Replace ECU” of “Read / Write Configuration” to save or print current Nissan Murano vehicle specification. Refer to Description.
-
After the ignition switch is turned OFF, the AV control unit continues operating for approximately 30 seconds.
-
Therefore, data corruption may occur if battery voltage is cut off within 30 seconds.
Disconnect the negative battery terminal. Refer to Removal and Installation.
Remove cluster lid D. Refer to Removal and Installation.
Remove A/C switch assembly. Refer to Removal and Installation.
Remove AV control unit screws then pull out AV control unit.
Disconnect the harness connectors from AV control unit and remove.
Remove AV control unit bracket (LH/RH) screws and AV control unit brackets [(LH/RH) (if necessary)].
INSTALLATION
CAUTION:
Be sure to perform “After Replace ECU” of “Read / Write Configuration” or “Manual Configuration” when replacing AV control unit. Refer to Description.
Installation is in the reverse order of removal.
Steering Switches
Exploded View
1.
Steering wheel
2.
Cover
3.
Steering switches
4.
Driver air bag module
A.
Refer to Exploded View.
Pawl
Removal and Installation
REMOVALNOTE:
The steering switches is serviced as an assembly...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Air Conditioner
CONSULT Function (BCM - AIR CONDITIONER) ECU IDENTIFICATIONThe BCM part number is displayed.SELF DIAGNOSTIC RESULTRefer to DTC Index.DATA MONITOR Monitor Item [Unit] Description FAN ON SIG [On/Off] Indicates condition of fan switch. AIR COND SW [On/Off] Indicates condition of A/C switch...
Nissan Murano (Z52) 2015-2024 Service Manual: C1a17 Icc Sensor
DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detection condition C1A17–(44, 45, 46, 47, 48, 49) CONTROL UNIT Diagnosis condition When Ignition switch is ON. Signal (terminal) — Threshold If distance sensor (ICC sensor) is malfunctioning Diagnosis delay time — NOTE: If any DTC “C1A17” is detected along with DTC “U1000”, first diagnose the DTC “U1000”...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Passenger compartment
- Settings
- Tire rotation
- New on site
- Most important about car
Autolight system
The autolight system allows the headlights to turn on and off automatically. The autolight system can:
Turn on the headlights, front parking, tail, license plate and instrument panel lights automatically when it is dark. Turn off all the lights (except daylight running lights) when it is light. Keep all the lights on for a period of time after you place the ignition switch in the OFF position and all doors are closed.