Nissan Murano: Removal and Installation / Around View Monitor Control Unit

Nissan Murano (Z52) 2015-2024 Service Manual / Driver Information & Multimedia / Audio, Visual & Navigation System :: Intelligent Around View Monitor with Navigation System / Removal and Installation / Around View Monitor Control Unit

Exploded View

Instrument panel assembly

Around view monitor control unit

Removal and Installation

REMOVAL

NOTE:

Before replacing around view monitor control unit, perform “Before Replace ECU” of “Read / Write Configuration” to save or print current Nissan Murano vehicle specification. Refer to Description.

Remove driver and passenger seat assembly. Refer to Removal and Installation.

Reposition driver and passenger seat away from center console.

Remove center console assembly. Refer to Removal and Installation.

Remove around view monitor control unit screws.

Disconnect the harness connectors from around view monitor control unit and remove.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:

Be sure to perform “After Replace ECU” of “Read / Write Configuration” or “Manual Configuration” when replacing around view monitor control unit. Refer to Description.

Perform the calibration and perform the writing to the around view monitor control unit when removing and replacing each camera, removing the camera mounting parts (front grille, door mirror, etc.) and replacing the around view monitor control unit. Refer to Description.

NOTE:

Perform predictive course line center position adjustment. Refer to Description.

Av Control Unit

Exploded View 1. AV control unit bracket (RH) 2. AV control unit 3. AV control unit bracket (LH) 4. A/C auto amp. Removal and Installation REMOVALCAUTION: Before disconnecting the AV control unit and battery terminals, turn the ignition switch OFF and wait at least 30 seconds...

Front Camera

Removal and Installation REMOVALRemove front grille. Refer to Removal and Installation. Disconnect the harness connector from the front camera. Remove screws (A) and remove front camera (1)...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: B2416 Touch Sen R Open

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC detecting condition B2416–1B TOUCH SEN R OPEN (Touch sensor right open) Diagnosis condition All times Signal (terminal) Touch sensor RH signal (automatic back door control module connector terminal: 4) Threshold When one of the following conditions is satisfied Touch sensor RH circuit is open Disconnect touch sensor RH connector Diagnosis delay time – B2416–1E TOUCH SEN R OPEN (Touch sensor right open) Diagnosis condition All times Signal (terminal) Touch sensor RH signal (automatic back door control module connector terminal: 4) Threshold When one of the following conditions is satisfied Touch sensor RH circuit is open Disconnect touch sensor RH connector Diagnosis delay time – POSSIBLE CAUSE Improper installation of touch sensor Touch sensor RH Harness or connectors (touch sensor circuit is open) Automatic back door control module FAIL-SAFEInhibit automatic back door system auto open/close function DTC Confirmation Procedure PERFORM DTC CONFIRMATION PROCEDURE CONSULT Ignition switch ON...

Nissan Murano (Z52) 2015-2024 Service Manual: C1b55-00 Radar Blockage

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition C1B55-00 RADAR BLOCKAGE (Radar blockage) Diagnosis condition When ignition switch is ON. Signal (terminal) – Threshold Side radar is blocked Diagnosis delay time – NOTE: DTC “C1B55-00” may be detected under the following conditions except for possible cause...