Nissan Murano: Monitor, climate, audio, phone and voice recognition systems / Antenna
The vehicle is equipped with a shark fin antenna and an antenna pattern is printed inside the rear window.
CAUTION
- Do not place metalized film near the rearwindowglass or attach any metal parts to it. Thismaycause poor reception or noise.
- When cleaning the inside of the rear window, be careful not to scratch or damage the rear window antenna. Lightly wipe along the antenna with a dampened soft cloth.
USB/iPod® charging port
2nd row
There are USB/iPod® charging ports located
in the 2nd row on the back of the
center console. These ports will charge
compatible devices.
NOTE:
Only the USB connection port(s) located
below the instrument panel will allow
operation of USB/iPod® devices through
the audio system...
Car phone or CB radio
When installing a CB, ham radio or car
phone in your vehicle, be sure to observe
the following precautions; otherwise, the
new equipment may adversely affect the
engine control system and other electronic
parts...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: P0222 Tp Sensor
DTC Description DTC DETECTION LOGIC An excessively low voltage from the TP sensor 1 is sent to ECM. An excessively high voltage from the TP sensor 1 is sent to ECM. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0222 TP SEN 1/CIRC-B1 (Throttle/Pedal position sensor/switch “B” circuit low) Diagnosis condition Start engine and let it idle Signal (terminal) Voltage signal transmitted from TP sensor 1 to ECM Threshold An excessively low voltage from the TP sensor 1 is sent to ECM Diagnosis delay time — P0223 TP SEN 1/CIRC-B1 (Throttle/Pedal position sensor/switch “B” circuit high) Diagnosis condition Start engine and let it idle Signal (terminal) Voltage signal transmitted from TP sensor 1 to ECM Threshold An excessively high voltage from the TP sensor 1 is sent to ECM Diagnosis delay time — POSSIBLE CAUSEP0222 Harness or connectors (TP sensor 1 circuit is open or shorted...
Nissan Murano (Z52) 2015-2024 Service Manual: Seat Belt Retractor
Removal and Installation WARNING: Before servicing the SRS, turn the ignition switch OFF, disconnect both battery terminals then wait at least three minutes. Do not drop the seat belt retractor. Always handle it with care. Always point pre-tensioner cylinder away from body when handling...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Indicator lights
- How to enable/disable the LDW system
- Rear bench seat adjustment
- New on site
- Most important about car
Autolight system
The autolight system allows the headlights to turn on and off automatically. The autolight system can:
Turn on the headlights, front parking, tail, license plate and instrument panel lights automatically when it is dark. Turn off all the lights (except daylight running lights) when it is light. Keep all the lights on for a period of time after you place the ignition switch in the OFF position and all doors are closed.
Copyright © 2026 www.nimurano.com