Nissan Murano: Monitor, climate, audio, phone and voice recognition systems / USB/iPod® charging port

2nd row
There are USB/iPod® charging ports located
in the 2nd row on the back of the
center console. These ports will charge
compatible devices.
NOTE:
Only the USB connection port(s) located
below the instrument panel will allow
operation of USB/iPod® devices through
the audio system.
The air conditioner system in your NISSAN
vehicle is charged with a refrigerant designed
with the environment in mind.
This refrigerant does not harm the
earth’s ozone layer...
The vehicle is equipped with a shark fin
antenna and an antenna pattern is printed
inside the rear window.
CAUTION
Do not place metalized film near the
rearwindowglass or attach any metal
parts to it...
Other information:
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
U0122
LOST COMM (BRAKE C/U)
(Lost Communication With Nissan Murano Vehicle Dynamics Control Module)
Diagnosis condition
When the ignition switch is ON
Signal
CAN communication signal
Threshold
TCM is unable to receive the CAN communications signal from ABS actuator and electric unit (control unit)
Diagnosis delay time
Continuously for 2 seconds or more
POSSIBLE CAUSE
ABS actuator and electric unit (control unit)
Harness or connector (CAN communication line is open or shorted)
FAIL-SAFENot changed from normal drivingDTC CONFIRMATION PROCEDURECHECK DTC PRIORITY
WhenDTC U0122 is displayed together with DTC U0300, diagnose first the DTC U0300...
DTC Description
NOTE:
The Signal Tech II Tool [- (J-50190)] can be used to perform the following functions: Refer to the Signal Tech II User Guide for additional information.
Check Intelligent Key relative signal strength.
Confirm Nissan Murano vehicle Intelligent Key antenna signal strength...
Categories

LATCH system lower anchor locations -
bench seat
Your vehicle is equipped with special anchor
points that are used with LATCH system
compatible child restraints. This system
may also be referred to as the ISOFIX
or ISOFIX compatible system. With this system,
you do not have to use a vehicle seat
belt to secure the child restraint unless the
combined weight of the child and child restraint
exceeds 65 lbs. (29.5 kg). If the combined
weight of the child and child restraint
is greater than 65 lbs. (29.5 kg), use the vehicle’s
seat belt (not the lower anchors) to
install the child restraint. Be sure to follow
the child restraint manufacturer’s instructions
for installation.
read more