Nissan Murano: Inspection and Adjustment / Zero Point Reset

Nissan Murano (Z52) 2015-2024 Service Manual / Restraints / Srs Air Bag Control System :: Basic Inspection / Inspection and Adjustment / Zero Point Reset

Description

Zero point reset is an initializing procedure for the OCS (weight) sensors that must be performed using CONSULT when removing and installing passenger seat or servicing the OCS system, including removing or installing OCS control unit and sensors. If zero point reset is not performed, the initialization is incomplete and OCS may not operate normally.

NOTE:

  • When reinstalling the passenger seat, the initial value for the OCS sensors may change, and the OCS may not operate normally.

  • When zero point reset is performed after removal and installation of passenger seat, CONSULT displays “complete”.

Special Repair Requirement

PERFORM ZERO POINT RESET

  1. Perform preliminary checks.

    NOTE:

    • Level the Nissan Murano vehicle.

    • Minimize vibrations near the vehicle.

    • Remove any objects on passenger seat.

    • Do not touch the Nissan Murano vehicle during zero point reset.

  2. Select “Start” on “Zero point reset function” screen from “Work support” mode of “OCCUPANT DETECTION”.

  3. “Zero point reset function” starts.

>>

GO TO 2.

CONFIRM RESET

Check that “Complete” is displayed on “Zero point reset function”.

CAUTION:

  • “Complete” may be displayed if the seat has been reinstalled or “zero point reset function” has already been performed.

  • “Incomplete” may be displayed if a new seat is installed.

  • Air bag warning lamp blinks in user mode if zero point reset is “incomplete”.

Is zero point reset status “complete”?

YES>>

Print out “Zero point reset current status” screen. Inspection End.

NO>>

Recheck the preliminary check items and perform zero point reset again.

    Additional Service When Replacing Control Unit

    Description AIR BAG DIAGNOSIS SENSOR UNITVehicle specifications are not yet written in a new air bag diagnosis sensor unit. It is therefore necessary to write the specifications to the new unit and then perform “Re/programming, Configuration” with CONSULT...

    Configuration

    Description Since vehicle specifications are not yet written in a new air bag diagnosis sensor unit, it is necessary to write the specifications to the new unit and then perform “Re/programming, Configuration” with CONSULT...

    Other information:

    Nissan Murano (Z52) 2015-2024 Owners Manual: Three-point type seat belt with retractor


    WARNING Every person who drives or rides in this vehicle should use a seat belt at all times. Children should be in the rear seats and in an appropriate restraint. Do not ride in a moving vehicle when the seatback is reclined. This can be dangerous...

    Nissan Murano (Z52) 2015-2024 Service Manual: P2118 Throttle Control Motor


    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P2118 ETC MOT-B1 (Throttle actuator control motor current range/performance) Diagnosis condition Start engine and let it idle Signal (terminal) Throttle control motor circuit Threshold ECM detects short in both circuits between ECM and throttle control motor Diagnosis delay time — POSSIBLE CAUSE Harness or connectors (Throttle control motor circuit is shorted...

    Categories

    Front manual seat adjustment (if so equipped)

    Your vehicle seats can be adjusted manually. For additional information about adjusting the seats, refer to the steps outlined in this section.

    Forward and backward

    Nissan Murano. Front manual seat adjustment (if so equipped)

    read more

     
    Copyright © 2026 www.nimurano.com