Nissan Murano: Inspection and Adjustment / Additional Service When Replacing Control Unit

Description

AIR BAG DIAGNOSIS SENSOR UNIT

Vehicle specifications are not yet written in a new air bag diagnosis sensor unit. It is therefore necessary to write the specifications to the new unit and then perform “Re/programming, Configuration” with CONSULT.

OCS CONTROL UNIT

WARNING:

Always perform zero point reset using CONSULT when removing and installing the front passenger seat or servicing the occupant classification system (OCS). If zero point reset is not performed, the OCS may not operate normally, which may increase the risk of serious injury in a collision.

WORK PROCEDURE WHEN REPLACING AIR BAG DIAGNOSIS SENSOR UNIT

SAVING VEHICLE SPECIFICATION

CONSULT

Read out the Nissan Murano vehicle specification from the old air bag diagnosis sensor unit and save the vehicle specification to CONSULT. Refer to “Configuration (reading)” in the “CONSULT Operation Manual”.

NOTE:

• For the air bag diagnosis sensor unit, the Type ID is stored in CONSULT.

• The Type ID is the part number (Nissan Murano vehicle specification) that is to be written to the air bag diagnosis sensor unit.

GO TO 2.

REPLACE AIR BAG DIAGNOSIS SENSOR UNIT

Replace air bag diagnosis sensor unit. Refer to Removal and Installation.

GO TO 3.

WRITING Nissan Murano Vehicle SPECIFICATION

CONSULT

Perform writing of the saved vehicle specification data according to the “Configuration” procedure in the “CONSULT Operation Manual”. Refer to Work Procedure.

Work End.

WORK PROCEDURE WHEN REPLACING OCS CONTROL UNIT

PERFORM ZERO POINT RESET

Perform zero point reset. Refer to Special Repair Requirement.

Inspection End.