Nissan Murano: Meter, Warning Lamp & Indicator :: Dtc/circuit Diagnosis / Washer Fluid Level Switch Circuit
CHECK WASHER FLUID LEVEL SWITCH SIGNAL CIRCUIT
-
Ignition switch OFF.
-
Disconnect combination meter harness connector and washer fluid level switch harness connector.
-
Check continuity between combination meter harness connector and washer fluid level switch harness connector.
Combination meter Washer fluid level switch Continuity Connector Terminal Connector Terminal M24 24 E208 1 Yes -
Check continuity between combination meter harness connector and ground.
Combination meter — Continuity Connector Terminal M24 24 Ground No
Is the inspection result normal?
YES>>GO TO 2.
NO>>Repair or replace harness or connector.
CHECK WASHER FLUID LEVEL SWITCH GROUND CIRCUIT
Check continuity between washer fluid level switch harness connector and ground.
| Washer fluid level switch | — | Continuity | |
|---|---|---|---|
| Connector | Terminal | ||
| E208 | 2 | Ground | Yes |
Is the inspection result normal?
YES>>Inspection End.
NO>>Repair or replace harness or connector.
CHECK WASHER FLUID LEVEL SWITCH
-
Ignition switch OFF.
-
Disconnect washer fluid level switch connector.
-
Check washer fluid level switch.
Washer fluid level switch Condition Continuity Terminals 1 2 Washer fluid level switch ON Yes Washer fluid level switch OFF No
Is the inspection result normal?
YES>>Inspection End.
NO>>Replace washer fluid level switch. Refer to Removal and Installation.
Fuel Level Sensor Signal Circuit
Component Function Check
COMBINATION METER INPUT SIGNAL
CONSULT
Select “Data Monitor” mode of “METER/M&A”.
Select “FUEL METER”.
Compare the “FUEL METER” value and the fuel gauge reading of the combination meter...
Steering Switch
Diagnosis Procedure
CHECK STEERING SWITCH CIRCUIT
Ignition switch OFF.
Disconnect combination meter harness connector and spiral cable harness connector...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: P0841 Transmission Fluid Pressure Sen/sw a
DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0841 FLUID PRESS SEN/SW A (Transmission Fluid Pressure Sensor/Switch “A” Circuit Range/Performance) Diagnosis condition When all of the following conditions are satisfied: TCM power supply voltage: More than 11 V DTC other than the applicable DTC is not detected...
Nissan Murano (Z52) 2015-2024 Service Manual: C1a27-97 Ecd Pwr Suply Circ
DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC detection condition C1A27-97 ECD PWR SUPLY CIR (ECD power supply circuit) Diagnosis condition When engine is running When MAIN switch of ICC system is ON Signal (terminal) — Threshold ECD system power supply voltage is excessively low Diagnosis delay time 60 second or more POSSIBLE CAUSE ABS actuator and electric unit (control unit) power supply circuit ABS actuator and electric unit (control unit) FAIL-SAFEThe following systems are canceled: Vehicle-to-vehicle distance control mode Conventional (fixed speed) cruise control mode Automatic Emergency Braking (AEB) with pedestrian detection Automatic Emergency Braking (AEB) Intelligent Forward Collision Warning (I-FCW) Rear Automatic Braking (RAB) Confirmation Procedure CHECK DTC PRIORITY If DTC “C1A27–97” is displayed with DTC “U1000–01”, “U0415–82” or “U0121–83”, first diagnose the DTC “U1000–01”, “U0415–82” or “U0121–83”...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Turning the AEB system on/off
- All-Wheel Drive (AWD) (if so equipped)
- Checking engine oil level
- New on site
- Most important about car
Vehicle security system
Your vehicle has two types of security systems:
Vehicle security system NISSAN Vehicle Immobilizer SystemThe vehicle security system provides visual and audible alarm signals if someone opens the doors, liftgate or the hood when the system is armed. It is not, however, a motion detection type system that activates when a vehicle is moved or when a vibration occurs.
