Nissan Murano: Intelligent Cruise Control (ICC) (if so equipped) / Vehicle-to-vehicle distance control mode
In the vehicle-to-vehicle distance control mode, the ICC system automatically maintains a selected distance from the vehicle traveling in front of you according to that vehicle’s speed (up to the set speed), or at the set speed when the road ahead is clear. The ICC system is intended to enhance the operation of the vehicle when following a vehicle traveling in the same lane and direction.
If the radar sensor 
detects a
slower moving
vehicle ahead, the system will reduce the
vehicle speed so that your vehicle follows the
vehicle in front at the selected distance.
The system automatically controls the throttle and applies the brakes (up to approximately 40% of vehicle braking power) if necessary.
The detection range of the sensor is approximately 650 ft (200 m) ahead.
How to select the cruise control mode
Selecting the vehicle-to-vehicle distance
control mode: To choose the
vehicle-to-vehicle distance control mode
, quickly push and release the
CRUISE
ON/OFF switch ...
Vehicle-to-vehicle distance control mode operation
The vehicle-to-vehicle distance control
mode is designed to maintain a selected
distance from the vehicle in front of you
and can reduce the speed to match a
slower vehicle ahead...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Moonroof
Diagnosis Procedure PERFORM INITIALIZATION PROCEDURE Perform initialization procedure. Refer to Special Repair Requirement. Is the inspection result normal? YES>> Moonroof system is normal. NO>> GO TO 2. CHECK MOONROOF SWITCH Check moonroof switch...
Nissan Murano (Z52) 2015-2024 Service Manual: Service Data and Specifications (sds). Service Data and Specifications (sds)
Idle Speed Condition Specification No load* (in P or N position) 625 ± 50 rpm *: Under the following conditions A/C switch: OFF Electric load: OFF (Lights, heater fan & rear window defogger) Steering wheel: Kept in straight-ahead position Ignition Timing Condition Specification No load* (in P or N position) 12 ± 2° BTDC *: Under the following conditions A/C switch: OFF Electric load: OFF (Lights, heater fan & rear window defogger) Steering wheel: Kept in straight-ahead position Calculated Load Value Condition Specification (Using CONSULT or GST) At idle 10 – 35 % At 2,500 rpm 10 – 35 % Mass Air Flow Sensor Supply voltage Approx...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Vehicle Dynamic Control (VDC) OFF switch
- System malfunction
- Intelligent Forward Collision Warning (I-FCW)
- New on site
- Most important about car
LATCH (Lower Anchors and Tethers for CHildren) system
LATCH system lower anchor locations - bench seat
Your vehicle is equipped with special anchor points that are used with LATCH system compatible child restraints. This system may also be referred to as the ISOFIX or ISOFIX compatible system. With this system, you do not have to use a vehicle seat belt to secure the child restraint unless the combined weight of the child and child restraint exceeds 65 lbs. (29.5 kg). If the combined weight of the child and child restraint is greater than 65 lbs. (29.5 kg), use the vehicle’s seat belt (not the lower anchors) to install the child restraint. Be sure to follow the child restraint manufacturer’s instructions for installation.
