Nissan Murano: Dtc/circuit Diagnosis / U1a06 Usb Comm
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | |
|---|---|---|---|
| U1A06 |
TEL ANTENNA ERROR (TEL antenna error) |
Diagnosis condition | When ignition switch is ON. |
| Signal (terminal) | TEL antenna signal | ||
| Threshold | No input | ||
| Diagnosis delay time | — | ||
POSSIBLE CAUSE
-
TEL antenna signal circuit
-
TEL antenna
-
TCU
FAIL-SAFE
-
Telematics switch LED indicator turned OFF (LED indicator turns ON 10 times when SOS call switch is pressed)
-
When telematics system is operated, inform that system cannot be connected to NissanConnect center
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
-
Ignition switch ON.
-
Select “Self Diagnostic Result” mode of “TELEMATICS”.
-
Check DTC.
Is DTC U1A06 detected?
YES>>Proceed to DTC Diagnosis Procedure.
NO>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO>>Confirmation after repair: Inspection End.
CHECK TELEMATICS ANTENNA
Visually check telematics antenna and antenna feeder. Refer to Removal and Installation.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Repair malfunctioning parts.
CHECK TCU VOLTAGE
-
Disconnect TCU harness connector.
-
Ignition switch ON.
-
Check voltage between TCU connector and ground.
TCU Ground Voltage
(Approx.)Connector Terminal M128 47 2.8 V
Is the inspection result normal?
YES>>Replace telematics antenna. Refer to Removal and Installation.
NO>>Replace TCU. Refer to Removal and Installation.
U1a05 Usb Comm
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
U1A05
USB COMM
(USB comm)
Diagnosis condition
When ignition switch is ON...
U1a0b Mic in Conn
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
U1A0B
MIC IN CONN
(MIC in conn)
Diagnosis condition
When ignition switch is ON...
Other information:
Nissan Murano (Z52) 2015-2024 Owners Manual: Hill start assist system
WARNING Never rely solely on the hill start assist system to prevent the vehicle from moving backward on a hill. Always drive carefully and attentively. Depress the brake pedal when the vehicle is stopped on a steep hill. Be especially careful when stopped on a hill on frozen or muddy roads...
Nissan Murano (Z52) 2015-2024 Service Manual: Diagnosis System (lane Camera Unit)
CONSULT Function (LANE CAMERA UNIT) APPLICATION ITEMSCONSULT performs the following functions by communicating with the lane camera unit. Diagnosis mode Description Work support Performs the camera aiming. Self Diagnostic Result Displays the name of a malfunctioning system stored in the lane camera unit Data Monitor Displays lane camera unit input/output data in real time Ecu Identification Displays lane camera unit part number CAN Diag Support Monitor Displays a reception/transmission state of CAN communication Configuration The Nissan Murano vehicle specification that is written in lane camera unit can be displayed or stored The vehicle specification can be written when lane camera unit is replaced SELF DIAGNOSTIC RESULTRefer to DTC Index...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Intelligent Forward Collision Warning (I-FCW)
- Indicator lights
- Jacking up vehicle and removing the damaged tire
- New on site
- Most important about car
Luggage hooks
When securing items using luggage hooks located on the back of the seat or side finisher do not apply a load over more than 6.5 lbs. (29 N) to a single hook.
The luggage hooks that are located on the floor should have loads less than 110 lbs. (490 N) to a single hook.
