Nissan Murano: Dtc/circuit Diagnosis / U1010 Control Unit(can)
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | |
|---|---|---|---|
| U1010 |
CONTROL UNIT(CAN) [Control unit(CAN)] |
Diagnosis condition | When ignition switch is ON |
| Signal (terminal) | — | ||
| Threshold | — | ||
| Diagnosis delay time | — | ||
POSSIBLE CAUSE
Around view monitor control unit
FAIL-SAFE
—
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
-
Ignition switch ON.
-
Select “Self Diagnostic Result” mode of “AVM”.
-
Check DTC.
Is DTC U1010 detected?
YES>>Proceed to DTC Diagnosis Procedure.
NO>>To check malfunction symptom before repair: Intermittent Incident.
NO>>Confirmation after repair: Inspection End.
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
-
Ignition switch ON.
-
Erase DTC.
-
Select “Self Diagnostic Result” mode of “AVM”.
-
Check DTC.
Is DTC U1010 detected?
YES>>Replace around view monitor control unit. Refer to Removal and Installation.
NO>>Inspection End.
U1000 Can Comm Circuit
DTC Description
DESCRIPTIONCAN (Controller Area Network) is a serial communication line for real-time application. It is an on-Nissan Murano vehicle multiplex communication line with high data communication speed and excellent error detection ability...
U111a Rear Camera Image Signal Circuit
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
U111A
REAR CAMERA IMAGE SIGNAL
(CAN COMM CIRCUIT)
Diagnosis condition
When ignition switch is ON
Signal (terminal)
Rear camera image signal (terminal 20)
Threshold
Rear camera image signal circuit is shorted or open
Diagnosis delay time
—
POSSIBLE CAUSE
Rear camera image signal circuit
Around view monitor control unit
Rear camera
FAIL-SAFECamera image is not displayed (gray screen display)
DTC Confirmation Procedure
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
Ignition switch ON...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Back-Up Lamp Circuit
Component Function Check CHECK BACK-UP LAMP OPERATION Start the engine. With operating the CVT shift selector, check that the back-up lamp is turned ON. CVT shift selector position: Reverse : Back-up lamp ON CVT shift selector position: Other than above : Back-up lamp OFF Is the inspection result normal? YES>> Back-up lamp circuit is normal...
Nissan Murano (Z52) 2015-2024 Service Manual: Preparation. Preparation
Special Service Tool The actual shape of the tools may differ from those illustrated here. Tool number (TechMate No.) Tool name Description — (J-8092) Driver handle Installing drive shaft oil seal (Use with J-52390) — (J-52390) Transfer case seal installer (1) Installing drive shaft oil seal ST33061000 (J-8107-2) Drift Removing ring gear bearing (left) inner race (transfer case side) a: 38 mm (1...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Fuel recommendation
- Turning the AEB system on/off
- Rear bench seat adjustment
- New on site
- Most important about car
Vehicle security system
Your vehicle has two types of security systems:
Vehicle security system NISSAN Vehicle Immobilizer SystemThe vehicle security system provides visual and audible alarm signals if someone opens the doors, liftgate or the hood when the system is armed. It is not, however, a motion detection type system that activates when a vehicle is moved or when a vibration occurs.
