Nissan Murano: Meter, Warning Lamp & Indicator :: Dtc/circuit Diagnosis / U1010 Control Unit(can)
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | |
|---|---|---|---|
| U1010 |
CONTROL UNIT (CAN) [CONTROL UNIT (CAN)] |
Diagnosis condition | When ignition switch is ON. |
| Signal (terminal) | - | ||
| Threshold | - | ||
| Diagnosis delay time | 2 seconds or more | ||
POSSIBLE CAUSE
Combination meter
FAIL-SAFE
The combination meter activates the fail-safe control if CAN communication with each unit is malfunctioning.
Refer to Fail-safe.
PERFORM SELF DIAGNOSTIC RESULT
CONSULT
-
Ignition switch ON.
-
Select “Self Diagnostic Result” mode of “METER/M&A”.
-
Check DTC.
Is DTC detected?
YES>>Refer to DTC Diagnosis Procedure.
NO>>Refer to Intermittent Incident.
REPLACE COMBINATION METER
Replace combination meter. Refer to Removal and Installation.
>>
Inspection End.
U1000 Can Comm Circuit
DTC Description
Refer to System Description.DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
U1000
CAN COMM CIRCUIT
(CAN COMM CIRCUIT)
Diagnosis condition
When ignition switch is ON...
B2205 Vehicle Speed
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
B2205
Nissan Murano Vehicle SPEED CIRC
[VEHICLE SPEED CIRC]
Diagnosis condition
When ignition switch is ON...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Component Parts. Intelligent Around View Monitor with Navigation System
Component Parts Location No. Component Function 1. Rear camera Refer to Rear Camera. 2. Door mirror RH (side camera) Refer to Side Cameras. 3. ABS actuator and electric unit (Control unit) Provides around view monitor control unit with wheel speed signal via CAN communication...
Nissan Murano (Z52) 2015-2024 Service Manual: Distance Sensor (icc Sensor) Alignment
Work Procedure Always perform the radar alignment after removing and installing or replacing the distance sensor.Application Notice Type Description TYPE 1 When using KV99112700 for radar alignment. Refer to Description. TYPE 2 When using 1-20-2851-1 for radar alignment...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Indicator lights
- Jacking up vehicle and removing the damaged tire
- All-Wheel Drive (AWD) (if so equipped)
- New on site
- Most important about car
LATCH (Lower Anchors and Tethers for CHildren) system
LATCH system lower anchor locations - bench seat
Your vehicle is equipped with special anchor points that are used with LATCH system compatible child restraints. This system may also be referred to as the ISOFIX or ISOFIX compatible system. With this system, you do not have to use a vehicle seat belt to secure the child restraint unless the combined weight of the child and child restraint exceeds 65 lbs. (29.5 kg). If the combined weight of the child and child restraint is greater than 65 lbs. (29.5 kg), use the vehicle’s seat belt (not the lower anchors) to install the child restraint. Be sure to follow the child restraint manufacturer’s instructions for installation.
