Nissan Murano: Meter, Warning Lamp & Indicator :: Dtc/circuit Diagnosis / B2205 Vehicle Speed

Nissan Murano (Z52) 2015-2024 Service Manual / Driver Information & Multimedia / Meter, Warning Lamp & Indicator :: Dtc/circuit Diagnosis / B2205 Vehicle Speed

DTC Description

DTC DETECTION LOGIC

DTC No.	CONSULT screen terms (Trouble diagnosis content)	DTC detection condition
B2205	Nissan Murano Vehicle SPEED CIRC [VEHICLE SPEED CIRC]	Diagnosis condition	When ignition switch is ON.
		Signal (terminal)	-
		Threshold	When an erroneous speed signal is received.
		Diagnosis delay time	2 seconds or more

POSSIBLE CAUSE

Wheel speed sensor
ABS actuator and electric unit (control unit)

FAIL-SAFE

—

DTC Confirmation Procedure

PERFORM SELF DIAGNOSTIC RESULT

CONSULT

Ignition switch ON.
Select “Self Diagnostic Result” mode of “METER/M&A”.
Check DTC.

Is DTC detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO>>

Refer to Intermittent Incident.

DTC Diagnosis Procedure

PERFORM SELF DIAGNOSTIC RESULT

CONSULT

Ignition switch ON.
Select “Self Diagnostic Result” mode of “ABS”.
Check DTC.

Is DTC detected?

YES>>

Perform diagnosis procedure on the detected DTC. Refer to DTC Index.

NO>>

Inspection End.

U1010 Control Unit(can)

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U1010 CONTROL UNIT (CAN) [CONTROL UNIT (CAN)] Diagnosis condition When ignition switch is ON...

Power Supply and Ground Circuit. Combination Meter

Diagnosis Procedure CHECK FUSES Check that the following fuses are not blown: Unit Power source Fuse No. Capacity Combination meter Battery 7 10 A 13 10 A Ignition switch ON or ACC 21 10 A Ignition switch ON or START 31 5 A Is the fuse blown? YES>> Replace the blown fuse after repairing the affected circuit...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: B2195 Anti-Scanning

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC Detection Condition B2195 ANTI-SCANNING (Anti-scanning) Diagnosis condition When ignition switch ON. Signal (terminal) — Threshold ID verification between BCM and ECM that is out of the designated specification is detected Diagnosis delay time — POSSIBLE CAUSEID verification request out of the designated specificationFAIL-SAFEInhibit engine cranking DTC Confirmation Procedure PERFORM DTC CONFIRMATION PROCEDURE CONSULT Ignition switch ON...

Nissan Murano (Z52) 2015-2024 Owners Manual: Cleaning exterior

In order to maintain the appearance of your vehicle, it is important to take proper care of it. To protect the paint surfaces, wash your vehicle as soon as you can: After a rainfall to prevent possible damage from acid rain. After driving on coastal roads...