Nissan Murano: Meter, Warning Lamp & Indicator :: Dtc/circuit Diagnosis / U1000 Can Comm Circuit

Nissan Murano (Z52) 2015-2024 Service Manual / Driver Information & Multimedia / Meter, Warning Lamp & Indicator :: Dtc/circuit Diagnosis / U1000 Can Comm Circuit

DTC Description

Refer to System Description.

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
U1000

CAN COMM CIRCUIT

(CAN COMM CIRCUIT)
Diagnosis condition When ignition switch is ON.
Signal (terminal) -
Threshold When combination meter is not transmitting or receiving CAN communication signals.
Diagnosis delay time 2 seconds or more

POSSIBLE CAUSE

CAN communication system

FAIL-SAFE

The combination meter activates the fail-safe control if CAN communication with each unit is malfunctioning.

Refer to Fail-safe.

DTC Confirmation Procedure

PERFORM SELF DIAGNOSTIC RESULT

CONSULT

  1. Ignition switch ON and wait for 2 seconds or more.

  2. Select “Self Diagnostic Result” mode of “METER/M&A”.

  3. Check DTC.

Is DTC detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO>>

Refer to Intermittent Incident.

DTC Diagnosis Procedure

CHECK CAN COMMUNICATION SYSTEM

Check CAN communication system. Refer to Trouble Diagnosis Flow Chart.

>>

Inspection End.

    Meter, Warning Lamp & Indicator :: Dtc/circuit Diagnosis

    ..

    U1010 Control Unit(can)

    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U1010 CONTROL UNIT (CAN) [CONTROL UNIT (CAN)] Diagnosis condition When ignition switch is ON...

    Other information:

    Nissan Murano (Z52) 2015-2024 Owners Manual: RAB system limitations


    WARNING Listed below are the system limitations for the RAB system. Failure to follow the warnings and instructions for proper use of the RAB system could result in serious injury or death. When the vehicle approaches an obstacle while the accelerator or brake pedal is depressed, the function may not operate or the start of operation may be delayed...

    Nissan Murano (Z52) 2015-2024 Service Manual: System Initialization


    Description Always perform the initialization when the battery terminal is disconnected or the driver seat control unit is replaced.The entry/exit assist function will not operate normally if no initialization is performed. Work Procedure INITIALIZATION PROCEDURECHOOSE METHOD There are two initialization methods...

    Categories

    read more

     
    Copyright © 2026 www.nimurano.com