Nissan Murano: Lane Departure Warning (LDW) (if so equipped) / System temporarily unavailable
If the vehicle is parked in direct sunlight
under high temperature conditions (over
approximately 104°F [40°C]) and then
started, the LDW system may be deactivated
automatically and the following
message will appear in the vehicle information
display: “Unavailable: High Cabin
Temperature.”
When the interior temperature is reduced,
the LDW system will resume operating automatically.
The LDW system is not designed to warn
under the following conditions:
- When you operate the lane change signal
and change traveling lanes in the
direction of the signal. (The LDWsystem
will become operable again approximately
2 seconds after the lane change
signal is turned off.)
- When the vehicle speed lowers to less
than approximately 37 mph (60 km/h).
After the above conditions have finished
and the necessary operating conditions
are satisfied, the LDWfunctions will resume.
WARNING
Listed below are the system limitations
for the LDWsystem. Failure to follow the
warnings and instructions for proper
use of the LDW system could result in
serious injury or death...
If the LDW system malfunctions, it will cancel
automatically. The LDW indicator (orange)
will illuminate in the display. If the
LDW indicator (orange) illuminates in the
display, pull off the road to a safe location
and stop the vehicle...
Other information:
Component Function Check
ACTIVE TEST
CONSULT
Select “MIRROR MOTOR RH” and “MIRROR MOTOR LH” in “Active Test” mode of “AUTO DRIVE POS.”.
Check that the function operates normally.
Test item Description
MIRROR MOTOR LH
UP
Door mirror LH
Upward
DWN
Downward
L
Leftward
R
Rightward
Off
Stop
MIRROR MOTOR RH
UP
Door mirror RH
Upward
DWN
Downward
L
Leftward
R
Rightward
Off
Stop
Is the inspection result normal?
YES>>
Door mirror motor function is OK...
Description
BEFORE REPLACEMENTWhen replacing AV control unit, save or print current vehicle specification with CONSULT configuration before replacement.NOTE:
If “Before Replace ECU” cannot be used, use the “After Replace ECU” or “Manual Configuration” after replacing AV control unit...