Nissan Murano: Rear Cross Traffic Alert (RCTA) (if so equipped) / System maintenance

Nissan Murano (Z52) 2015-2024 Owners Manual / Starting and driving / Rear Cross Traffic Alert (RCTA) (if so equipped) / System maintenance

Nissan Murano. System maintenance

The two radar sensors Nissan Murano. System maintenance for the BSW and RCTA systems are located near the rear bumper. Always keep the area near the radar sensors clean.

The radar sensors may be blocked by temporary ambient conditions such as splashing water, mist or fog.

The blocked condition may also be caused by objects such as ice, frost or dirt obstructing the radar sensors.

Check for and remove objects obstructing the area around the radar sensors.

Do not attach stickers (including transparent material), install accessories or apply additional paint near the radar sensors.

Do not strike or damage the area around the radar sensors. It is recommended that you visit a NISSAN dealer if the area around the radar sensors is damaged due to a collision.

Radio frequency statement

For USA

FCC ID: OAYSRR2B or OAYSRR3B

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

  1. This device may not cause harmful interference, and
  2. This device must accept any interference received, including interference that may cause undesired operation.

FCC Warning

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

For Canada

Applicable law: Canada 310

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:

  1. This device may not cause interference, and
  2. This device must accept any interference, including interference that may cause undesired operation of the device.

Frequency bands: 24.05 – 24.25GHz

Output power: less than 20 milliwatts

Droit applicable: Canada 310

Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes:

  1. L’appareil ne doit pas produire de brouillage, et
  2. L’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.

Bandes de fréquences: 24.05 - 24.25GHz

Puissance émise: Moins de 20 milliwatts

    System temporarily unavailable

    When radar blockage is detected, the system will be deactivated automatically. The “Unavailable: Side Radar Obstruction” warning message will appear and the BSW/RCTA indicator (white) will blink in the vehicle information display...

    Cruise control (if so equipped)

    ..

    Other information:

    Nissan Murano (Z52) 2015-2024 Service Manual: Component Parts. Power Distribution System


    Component Parts Location A. Front of center console B. Instrument lower panel LH No. Component Function 1. Push-button ignition switch Refer to Push-Button Ignition Switch. 2. IPDM E/R (Intelligent Power Distribution Module Engine Room) IPDM E/R detects the push-button ignition switch status, and transmits the push-button ignition switch status signal (CAN) to BCM...

    Nissan Murano (Z52) 2015-2024 Service Manual: Additional Service When Replacing Ecm


    Description When replacing ECM, the following procedure must be performed. (For details, refer to Work Procedure.)CAUTION: When replacing the ECM, always replace it with a new one. The functions controlled by the ECM does not operate properly in case of reuse of the ECM from another Nissan Murano vehicle...

    Categories

    Luggage hooks

    Nissan Murano. Luggage hooks

    When securing items using luggage hooks located on the back of the seat or side finisher do not apply a load over more than 6.5 lbs. (29 N) to a single hook.

    The luggage hooks that are located on the floor should have loads less than 110 lbs. (490 N) to a single hook.

    read more

     
    Copyright © 2026 www.nimurano.com