Nissan Murano: Starting and driving / Cruise control (if so equipped)

System maintenance

The two radar sensors for the BSW and RCTA systems are located near the rear bumper. Always keep the area near the radar sensors clean. The radar sensors may be blocked by temporary ambient conditions such as splashing water, mist or fog...

Precautions on cruise control

CANCEL switch RES/+ switch SET/- switch ON/OFF switch If the cruise control system malfunctions, it cancels automatically. The indicator in the vehicle information display then blinks to warn the driver...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Door Striker

Removal and Installation REMOVALRemove bolts and rear door striker.INSTALLATIONInstallation is in the reverse order of removal.CAUTION: Do not reuse rear door striker bolts. Tighten bolts to specification. Refer to Exploded View. After installation, check rear door open/close operation...

Nissan Murano (Z52) 2015-2024 Service Manual: P0705 Transmission Range Sensor a

DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0705 T/M RANGE SENSOR A [Transmission Range Sensor A Circuit (PRNDL Input)] Diagnosis condition TCM power supply voltage: More than 11 V Signal Transmision range switch signal Threshold Two or more range signals simultaneously stay ON continuously Diagnosis delay time Maintained for 2 seconds POSSIBLE CAUSE Harness or connector (Short circuit between transmission range switch and TCM) Transmission range switch FAIL-SAFE Shift position indicator on combination meter is not displayed Selector shock is large Start is slow Acceleration is slow Lock-up is not performed DTC Confirmation Procedure PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test...