Nissan Murano: Starting and driving / Rear Cross Traffic Alert (RCTA) (if so equipped)
WARNING
Failure to follow the warnings and instructions
for proper use of the RCTA
system could result in serious injury or
death.
- The RCTA system is not a replacement
for proper driving procedures and is
not designed to prevent contact with
vehicles or objects. When backing out
of a parking space, always use the
side and rear mirrors and turn and
look in the direction your vehicle will
move. Never rely solely on the RCTA
system.
The RCTA system will assist you when
backing out from a parking space. When
the vehicle is in reverse, the system is designed
to detect other vehicles approaching
fromthe right or left of the vehicle. If the
system detects cross traffic, it will alert you.
The two radar sensors for the
BSW and
RCTA systems are located near the rear
bumper. Always keep the area near the radar
sensors clean.
The radar sensors may be blocked by temporary
ambient conditions such as splashing
water, mist or fog...
Side BSW/RCTA Indicator Light
BSW/RCTA Indicator
The RCTA system can help alert the driver
of an approaching vehicle when the driver
is backing out of a parking space...
Other information:
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen items
(Trouble diagnosis content) DTC detecting condition
B2409–71
HALF LATCH SW
(Half latch switch)
Diagnosis condition
All times
Signal (terminal)
Half latch switch signal (automatic back door control module connector terminal: 7)
Threshold
When all of the following conditions are satisfied
Back door: half latch or open
Half latch switch: ON → OFF
Diagnosis delay time
–
POSSIBLE CAUSE
Entry of foreign materials to back door lock assembly
Back door mechanism
Half latch switch
Harness or connectors (half latch switch circuit is open or shorted)
Automatic back door control module
FAIL-SAFEInhibit automatic back door system auto open/close function
DTC Confirmation Procedure
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
Ignition switch ON...
Component Function Check
CHECK BRAKE WARNING LAMP FUNCTION (1)
Check that brake warning lamp in combination meter turns ON for 1 second after ignition switch ON.
CAUTION:
Never start the engine.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Proceed to Diagnosis Procedure...