Nissan Murano: Inspection and Adjustment / System Initialization

Nissan Murano (Z52) 2015-2024 Service Manual / Body Interior / Automatic Drive Positioner :: Basic Inspection / Inspection and Adjustment / System Initialization

Description

Always perform the initialization when the battery terminal is disconnected or the driver seat control unit is replaced.

The entry/exit assist function will not operate normally if no initialization is performed.

Work Procedure

INITIALIZATION PROCEDURE

CHOOSE METHOD

There are two initialization methods.

Which method do you use?

With door switch>>

GO TO 2.

With Nissan Murano vehicle speed>>

GO TO 4.

STEP A-1

Ignition switch from ACC to OFF.

GO TO 3.

STEP A-2

Driver door switch is ON (open) → OFF (close) → ON (open).

Inspection End.

STEP B-1

Drive the Nissan Murano vehicle at more than 25 km/h (16 MPH).

Inspection End.

Additional Service When Replacing Control Unit

Description Each function is reset to the following condition when the driver seat control unit is replaced. Function Condition Procedure Memory (Seat, steering column, door mirror) Erased Perform storing Entry/exit assist ON Perform initialization Set slide amount*1 Linking a key fob to meter display Erased Perform initialization Perform storing *1: Default value is 40 mm...

Memory Storing

Description Always perform the memory storage when the battery terminal is disconnected or the driver seat control unit is replaced. The memory function will not operate normally if no memory storage is performed...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: System Description. Structure and Operation

Sectional View Drive gear Side bearing Differential case Pinion mate shaft Side gear Pinion mate gear Drive pinion Collapsible spacer AWD solenoid Stud bolt Electric controlled coupling Pinion front bearing Pinion rear bearing Electric Controlled Coupling The electric controlled coupling operates as the AWD system...

Nissan Murano (Z52) 2015-2024 Service Manual: P1614 Chain of Immu-Key

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC Detection Condition P1614 CHAIN OF IMMU-KEY (Chain of immobilizer-key) Diagnosis condition When ignition switch ON. Signal (terminal) — Threshold Inactive communication between NATS antenna amp...