Nissan Murano: Body Interior / Automatic Drive Positioner :: Basic Inspection

Nissan Murano (Z52) 2015-2024 Service Manual / Body Interior / Automatic Drive Positioner :: Basic Inspection

Bcm (body Control Module)

L..

Diagnosis and Repair Work Flow

Work Flow WORK FLOWDETAILED FLOWGET INFORMATION FOR SYMPTOM Get the detailed information from the customer about the symptom (the condition and the environment when the incident/malfunction occurred)...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: P2101 Electric Throttle Control Function


DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P2101 ETC FNCTN/CIRC-B1 (Throttle actuator “A” control motor circuit range/performance) Diagnosis condition Start engine and let it idle Signal (terminal) — Threshold Electric throttle control function does not operate properly Diagnosis delay time — POSSIBLE CAUSE Harness or connectors (Throttle control motor circuit is open or shorted) Electric throttle control actuator FAIL-SAFE Engine operating condition in fail-safe mode Fail safe mode Nissan Murano Vehicle behavior Electric throttle control function ECM stops the electric throttle control actuator control, throttle valve is maintained at a fixed opening (approx...

Nissan Murano (Z52) 2015-2024 Service Manual: L Terminal Circuit (short)


Diagnosis Procedure CHECK “L” TERMINAL CIRCUIT (SHORT) Ignition switch OFF. Disconnect generator connector. Ignition switch ON. Does charge warning lamp illuminate? YES>> GO TO 2. NO>> Refer to Work Flow (With 165-DSS-5000P), or (Without 165-DSS-5000P)...

Categories

LATCH (Lower Anchors and Tethers for CHildren) system

Nissan Murano. LATCH (Lower Anchors and Tethers for CHildren) system

LATCH system lower anchor locations - bench seat

Your vehicle is equipped with special anchor points that are used with LATCH system compatible child restraints. This system may also be referred to as the ISOFIX or ISOFIX compatible system. With this system, you do not have to use a vehicle seat belt to secure the child restraint unless the combined weight of the child and child restraint exceeds 65 lbs. (29.5 kg). If the combined weight of the child and child restraint is greater than 65 lbs. (29.5 kg), use the vehicle’s seat belt (not the lower anchors) to install the child restraint. Be sure to follow the child restraint manufacturer’s instructions for installation.

read more

 
Copyright © 2026 www.nimurano.com