Nissan Murano: Inspection and Adjustment / Memory Storing
Always perform the memory storage when the battery terminal is disconnected or the driver seat control unit is replaced. The memory function will not operate normally if no memory storage is performed.
Memory Storage Procedure
Two positions for the driver seat, steering column and outside mirror can be stored for memory operation by the following procedure:
STEP 1
Check the following conditions:
-
Ignition switch: ON
-
CVT shift selector: P (Park) position
>>
GO TO 2.
STEP 2
Adjust driver seat, steering column and outside mirror position manually.
>>
GO TO 3.
STEP 3
-
Push set switch.
NOTE:
-
Memory indicator for which driver seat position is already retained in memory is illuminated for 5 seconds.
-
Memory indicator for which driver seat position is not retained in memory is illuminated for 0.5 seconds.
-
-
Push the memory switch (1 or 2) for at least 1 second within 5 seconds after pushing the set switch.
NOTE:
-
To enter driver seat positions into blank memory, memory indicator will be turned on for 5 seconds.
-
To modify driver seat positions, memory indicator will be turned OFF for 0.5 seconds then turned ON for 5 seconds.
NOTE:
If memory is stored in the same memory switch, the previous memory will be deleted.
-
>>
GO TO 4.
STEP 4
Confirm the operation of each part with memory operation.
>>
Inspection End.
System Initialization
Description
Always perform the initialization when the battery terminal is disconnected or the driver seat control unit is replaced.The entry/exit assist function will not operate normally if no initialization is performed...
Linking Key Fob to the Meter Display
Description
Always perform when the battery terminal is disconnected or the driver seat control unit is replaced. Linking key fob to the meter display will not operate normally if no memory storage is performed...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: U0428 Steering Angle Sensor
DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U0428 ST ANGLE SENSOR CALIBRATION (Steering angle sensor calibration) Diagnosis condition When ignition switch is ON Signal (terminal) — Threshold — Diagnosis delay time — POSSIBLE CAUSE Neutral position adjustment of steering angle sensor is not complete Steering angle sensor FAIL-SAFE Predicted course line is not displayed MOD (Moving Object Detection) function is stopped DTC Confirmation Procedure CHECK DTC PRIORITY If DTC U0428 is displayed with DTC U1232, first perform the diagnosis for DTC U1232...
Nissan Murano (Z52) 2015-2024 Service Manual: Engine Does Not Start When Intelligent Key Is Inside of Vehicle (one Key)
Diagnosis Procedure Engine does not start when ignition switch is pressed. (One Intelligent Key has the symptom, other keys operate normally.)SYMPTOM TABLE (ONE INTELLIGENT KEY HAS THE SYMPTOM, OTHER KEYS OPERATE NORMALLY) Door lock operation (remote keyless entry) Door lock operation (request switch) or back door open operation (opener switch of back door panel) Engine started with push-button ignition switch operation (Intelligent Key is within the detection area of inside key antenna) Engine started with push-button ignition switch operation (registered Intelligent Key placed next to push-button ignition switch) OK OK No crank, No start No crank, No start DIAGNOSIS PROCEDURERefer to Diagnosis Procedure...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Tire rotation
- Settings
- All-Wheel Drive (AWD) (if so equipped)
- New on site
- Most important about car
Front manual seat adjustment (if so equipped)
Your vehicle seats can be adjusted manually. For additional information about adjusting the seats, refer to the steps outlined in this section.
Forward and backward
