Nissan Murano: Cruise Control System :: Icc / System Description

Nissan Murano (Z52) 2015-2024 Service Manual / Cruise Control & Driver Assistance / Cruise Control System :: Icc / System Description

Preparation. Preparation

Special Service Tools The actual shape of the tools may differ from those illustrated here. Tool number (TechMate No.) Tool name Description   — (1-20-2851-1) Radar Sensor Aiming kit* Adjusting distance and radar sensors * NOTE: Tools 1–20–2721–1–IF, 1–20–2722–1–IF and J-50808 have been superseded and are no longer available, but may still be used for distance sensor alignment...

Component Parts. Intelligent Cruise Control System

Component Parts Location A. Center of instrument panel (view with center console assembly removed) B. Engine room right side C. Center area of front bumper D...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: P2100 Throttle Control Motor Relay


DTC Description DTC DETECTION LOGIC ECM detects that the voltage of power source for throttle control motor is excessively low. ECM detects that the throttle control motor relay is stuck ON. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P2100 ETC MOT PWR-B1 (Throttle actuator “A” control motor circuit/open) Diagnosis condition Start engine and let it idle Signal (terminal) Throttle control motor circuit Threshold ECM detects that the voltage of power source for throttle control motor is excessively low Diagnosis delay time — P2103 ETC MOT PWR-B1 (Throttle actuator “A” control motor circuit high) Diagnosis condition Ignition switch ON Signal (terminal) Throttle control motor circuit Threshold ECM detects that the throttle control motor relay is stuck ON Diagnosis delay time — POSSIBLE CAUSEDTC P2100 Harness or connectors (Throttle control motor relay circuit is open) Throttle control motor relay DTC P2103 Harness or connectors (Throttle control motor relay circuit is shorted) Throttle control motor relay FAIL-SAFE Engine operating condition in fail-safe mode Fail safe mode Nissan Murano Vehicle behavior Throttle control motor relay ECM stops the electric throttle control actuator control, throttle valve is maintained at a fixed opening (approx...

Nissan Murano (Z52) 2015-2024 Service Manual: Preparation. Preparation


Special Service Tools The actual shape of the tools may differ from those illustrated here. Tool number (TechMate No.) Tool name Description A. — (J-52389) Engine support tool B. — (J-52604) Engine support bracket Supporting engine — (J-51307) CVT transmission jack adapter Removing CVT KV311039S0 ( — ) Charging pipe set KV31103920* ( — ) O-ring CVT fluid changing and adjustment ( — ) (J-52584) CVT stand pipe adapter kit CVT fluid changing and adjustment KV38107900 (J-52469–1) Differential side oil seal protector Installing drive shaft A: 32 mm (1...

Categories

Driver and passenger supplemental knee air bag

Nissan Murano. Driver and passenger supplemental knee air bag

Driver’s side

The knee air bag is located in the knee bolster, on the driver’s and passenger’s side. All of the information, cautions and warnings in this manual apply and must be followed. The knee air bag is designed to inflate in higher severity frontal collisions, although it may inflate if the forces in another type of collision are similar to those of a higher severity frontal impact. It may not inflate in certain collisions.

Nissan Murano. Driver and passenger supplemental knee air bag

Passenger’s side

read more

 
Copyright © 2026 www.nimurano.com