Nissan Murano: Auto Operation Does Not Operate / Sunshade
PERFORM INITIALIZATION PROCEDURE
Refer to Special Repair Requirement.
Is the inspection result normal?
YES>>Sunshade system is normal.
NO>>GO TO 2.
CHECK SUNSHADE SWITCH
Check sunshade switch.
Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>GO TO 3.
NO>>Repair or replace the malfunctioning parts.
CONFIRM THE OPERATION
Confirm the operation again.
Is the result normal?
YES>>Check intermittent incident. Refer to Intermittent Incident.
NO>>GO TO 1.
Moonroof
Diagnosis Procedure
PERFORM INITIALIZATION PROCEDURE
Perform initialization procedure.
Refer to Special Repair Requirement.
Is the inspection result normal?
YES>>
Moonroof system is normal...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Light Reminder Warning
Light Reminder Warning SYSTEM DIAGRAMWARNING CHIME OPERATION CONDITIONSIf all of the following conditions are fulfilled: Operation conditions Ignition switch OFF Combination switch (Lighting switch) 1st or 2nd position Driver side door Open [front door switch LH ON] WARNING CHIME CANCEL CONDITIONSWarning is canceled if any of the following conditions are fulfilled: Operation conditions Ignition switch ON Combination switch (Lighting switch) OFF or AUTO position Driver side door Close [front door switch LH OFF] SIGNAL PATH BCM requires warning chime output to combination meter when it judges light reminder warning chime is necessary from signals below...
Nissan Murano (Z52) 2015-2024 Owners Manual: Trailer lights
CAUTION When splicing into the vehicle electrical system, a commercially available power-type module/converter must be used to provide power for all trailer lighting. This unit uses the vehicle battery as a direct power source for all trailer lights while using the vehicle tail light, stop light and turn signal circuits as a signal source...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Jacking up vehicle and removing the damaged tire
- Settings
- Rear bench seat adjustment
- New on site
- Most important about car
LATCH (Lower Anchors and Tethers for CHildren) system
LATCH system lower anchor locations - bench seat
Your vehicle is equipped with special anchor points that are used with LATCH system compatible child restraints. This system may also be referred to as the ISOFIX or ISOFIX compatible system. With this system, you do not have to use a vehicle seat belt to secure the child restraint unless the combined weight of the child and child restraint exceeds 65 lbs. (29.5 kg). If the combined weight of the child and child restraint is greater than 65 lbs. (29.5 kg), use the vehicle’s seat belt (not the lower anchors) to install the child restraint. Be sure to follow the child restraint manufacturer’s instructions for installation.
