Nissan Murano: Auto Operation Does Not Operate / Moonroof
Diagnosis Procedure
PERFORM INITIALIZATION PROCEDURE
Perform initialization procedure.
Refer to Special Repair Requirement.
Is the inspection result normal?
YES>>
Moonroof system is normal.
NO>>
GO TO 2.
CHECK MOONROOF SWITCH
Check moonroof switch.
Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>
GO TO 3.
NO>>
Repair or replace the malfunctioning parts.
CONFIRM THE OPERATION
Confirm the operation again.
Is the inspection result normal?
YES>>
Check intermittent incident. Refer to Intermittent Incident.
NO>>
GO TO 1.
Diagnosis Procedure
PERFORM INITIALIZATION PROCEDURE
Refer to Special Repair Requirement.
Is the inspection result normal?
YES>>
Sunshade system is normal...
Other information:
Condition A:
The warning and assist functions of the I-LI
system are not designed to work under the
following conditions:
When you operate the lane change signal
and change the traveling lanes in
the direction of the signal. (The I-LI system
will be deactivated for approximately
2 seconds after the lane change
signal is turned off...
The High Beam Assist system will operate
when the vehicle is driven at speeds of approximately
25mph(40 km/h) and above. If
an oncoming vehicle or leading vehicle appears
in front of your vehicle when the
headlight high beam is on, the headlight
will be switched to the low beamautomatically...