Nissan Murano: Maintenance and schedules / Standard maintenance

Maintenance schedules

To help ensure smooth, safe and economical driving, NISSAN provides two maintenance schedules that may be used, depending upon the conditions in which you usually drive...

Emission control system maintenance

Abbreviations: I = Inspect and correct or replace as necessary, R = Replace NOTE: (1) After 40,000 miles (64,000 km) or 48 months, inspect every 10,000 miles (16,000 km) or 12 months...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: P219a Air Fuel Ratio

DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P219A AIR FUEL RATIO IMBALANCE B1 (Air-fuel ratio imbalance bank 1) Diagnosis condition — Signal (terminal) — Threshold ECM detects a lean/rich air fuel ratio state in any cylinder for a specified length of time Diagnosis delay time — P219B AIR FUEL RATIO IMBALANCE B2 (Air-fuel ratio imbalance bank 2) Diagnosis condition — Signal (terminal) — Threshold ECM detects a lean/rich air fuel ratio state in any cylinder for a specified length of time Diagnosis delay time — POSSIBLE CAUSEDTC P219A Fuel injector Exhaust gas leaks Incorrect fuel pressure Mass air flow sensor Intake air leaks Lack of fuel Incorrect PCV hose connection Improper spark plug Insufficient compression The fuel injector circuit is open or shorted Ignition coil The ignition signal circuit is open or shorted DTC P219B Fuel injector Exhaust gas leaks Incorrect fuel pressure Mass air flow sensor Intake air leaks Lack of fuel Incorrect PCV hose connection Improper spark plug Insufficient compression The fuel injector circuit is open or shorted Ignition coil The ignition signal circuit is open or shorted FAIL-SAFENot applicable DTC Confirmation Procedure CHECK DTC PRIORITY If DTC P219A or P219B is displayed with other DTC, first perform the trouble diagnosis for the other DTC...

Nissan Murano (Z52) 2015-2024 Service Manual: Sunshade Motor Assembly

Removal and Installation REMOVALRemove the headlining. Refer to Removal and Installation. Disconnect the harness connector (A) from the sunshade motor assembly (1). Remove sunshade motor assembly screws (B). Remove the sunshade motor assembly from the moonroof unit assembly (2)...