Nissan Murano: Power moonroof (if so equipped) / Sliding the moonroof. Tilting the moonroof
Sliding the moonroof
To open the moonroof, push the switch to
the open 
position and release it;
it need
not be held. The roof will automatically
open or close all the way.
Press the switch again to fully open the moonroof.
To close the moonroof, push the switch to
the 
position and release it. The
roof will
automatically close all the way.
To stop the moonroof, push the switch once more while it is opening or closing.
Tilting the moonroof
To tilt the moonroof up, first close the
moonroof. Push the switch to the 
position
and release it; it need not be held.
To tilt down the moonroof, push the switch
to the 
position and release it.
Auto-reverse function
The auto-reverse function can be activated
when a window is closed by automatic
operation.
Depending on the environment or driving
conditions, the auto-reverse function
may be activated if an impact or
load similar to something being caught
in the window occurs...
Auto-reverse function (when closing or tilting down the moonroof)
The auto-reverse function can be activated
when the moonroof is closed or
tilted down by automatic operation when
the ignition switch is placed in the ON position
or for a period of time after the ignition
switch is placed in the OFF position...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Additional Service When Replacing Control Unit. Ecm
Description Performing the following procedure can automatically activate recommunication of ECM and BCM, but only when the ECM is replaced with a new one*.*: New one means an ECM that has never been energized on-board.(In this step, initialization procedure by CONSULT is not necessary)CAUTION: When replacing the ECM, a new ECM must be used...
Nissan Murano (Z52) 2015-2024 Service Manual: P2610 Ecm Internal Timer
DTC Description DESCRIPTIONThis ECM contains a timer and measures time between an ignition switch OFF and the next ignition switch ON. This enables the judging of the state of engine cooling at an engine start.DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P2610 ECM/PCM INTERNAL ENG OFF TIMER (ECM/PCM internal engine off timer performance) 1 Diagnosis condition — Signal (terminal) — Threshold ECM internal engine off timer is malfunctioning Diagnosis delay time — 2 Diagnosis condition — Signal (terminal) — Threshold The time calculated by ECM based on a descent allowance of engine coolant temperatures during ignition switch OFF is extremely shorter than the time counted by the Engine internal OFF timer Diagnosis delay time — POSSIBLE CAUSE ECM ECM power supply FAIL-SAFENot applicable DTC Confirmation Procedure INSPECTION START It is necessary to erase permanent DTC? YES>> GO TO 4...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Indicator lights
- All-Wheel Drive (AWD) (if so equipped)
- How to enable/disable the LDW system
- New on site
- Most important about car
Seatback pockets
Theremaybe one or two seatback pockets located on the back of the driver and passenger seats. The pockets can be used to store maps.
WARNING
