Nissan Murano: Driveline :: Transfer: Ty21c / Service Data and Specifications (sds). Service Data and Specifications (sds)

Nissan Murano (Z52) 2015-2024 Service Manual / Transmission & Driveline / Driveline :: Transfer: Ty21c / Service Data and Specifications (sds). Service Data and Specifications (sds)

General Specifications

Applied model	Axle	AWD
	Engine	VQ35DE
	Transaxle	CVT
Transfer model		TY21C
Gear ratio		0.404
Number of teeth	Ring gear	42
Number of teeth	Drive pinion	17
Oil capacity		Refer to Fluids and Lubricants.

Preload Torque

Unit: N·m (kg-m, in-lb)

Item		Standard
Pinion bearing preload (P₁)		0.25 – 1.15 (0.03 – 0.11, 3.0 – 10.0)
Total preload	With all oil seals	P₁ + 0.7 – 1.0 (0.08 – 0.1, 7.0 – 8.0)
Total preload	Without oil seals (for transfer cover and transfer case)	P₁ + 0.5 – 0.8 (0.06 – 0.08, 5.0 – 7.0)

Backlash

Unit: mm (in)

Item	Standard
Ring gear to drive pinion	0.16 – 0.21 (0.0063 – 0.0083)

Companion Flange Runout

Unit: mm (in)

Item	Standard
Companion flange face runout	0.15 (0.0059) or less
Inner side of the companion flange runout	0.1 (0.004) or less

Transfer Case

Exploded View Oil seal Transfer cover Filler plug Gasket Drain plug Oil seal O-ring Ring gear bearing adjusting shim (transfer cover side) Ring gear bearing (transfer cover side) Drive shaft oil seal Ring gear shaft Ring gear bearing (transfer case side) Ring gear bearing adjusting shim (transfer case side) Ring gear Baffle plate Transfer case Plug O-ring Oil seal Dowel pin Drive pinion Drive pinion adjusting shim O-ring Pinion bearing assembly Oil seal Dust cover Companion flange Pinion lock nut Oil seal lip Comply with the assembly procedure when tightening...

Driveline :: Rear Propeller Shaft: C-Cvj-C

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Clutch Point Learning

Description TCM memorizes a clutch point (engagement timing), and this enables accurate control. For work procedure, refer to Work Procedure. Work Procedure CLUTCH POINT LEARNING With CONSULT Start the engine. Select “Work Support” in “TRANSMISSION”...

Nissan Murano (Z52) 2015-2024 Service Manual: C1b82-97 Dist Sen Off-Center

DTC Description DTC DETECTION LOGIC DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition C1B82-97 DIST SEN OFF-CENTER (Distance sensor off-center) Diagnosis condition When engine is running Signal (terminal) — Threshold Distance sensor is off the alignment point Diagnosis delay time 1 second or less POSSIBLE CAUSE Radar alignment is off the aiming point ADAS control unit FAIL-SAFEThe following systems are canceled: Vehicle-to-vehicle distance control mode Conventional (fixed speed) cruise control mode Automatic Emergency Braking (AEB) with pedestrian detection Automatic Emergency Braking (AEB) Intelligent Forward Collision Warning (I-FCW) Lane Departure Warning (LDW) Intelligent Lane Intervention (I-LI) Confirmation Procedure PERFORM DTC CONFIRMATION PROCEDURE CONSULT Start the engine...