Nissan Murano: Basic Inspection / Select Learning

Work Procedure

NOTE:

• If Clutch Point Learning is also required, always perform Clutch Point Learning before Select Learning.

• Perform Select Learning with CVT fluid temperature below 50°C (122°F) and again with fluid temperature above 50°C (122°F).

PERFORM SELECT LEARNING (DRIVE/REVERSE LEARNING)

1. Set the parking brake.

2. Start the engine and wait 5 seconds.

3. Shift the selector lever to the N position and hold more than 2 seconds, then to D position and wait for transmission engagement.

4. Repeat step 3 ten (10) times.

5. Shift the selector lever to the N position and hold more than 2 seconds, then to R position and wait for transmission engagement.

6. Repeat step 5 ten (10) times.

7. Shift the selector lever to the P position and turn the ignition OFF.

WORK END