Nissan Murano: Engine / Starting System :: Service Data and Specifications (sds). Starter Motor

Starting System :: Removal and Installation. Starter Motor

Exploded View 1. Cylinder block 2. Shim 3. Starter 4. "B" terminal harness 5. "S" connector Removal and Installation NOTE: When removing components such as hoses, tubes/ lines, etc...

Accelerator Control System :: Precaution. Precautions

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collisions...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: P0740 Torque Converter

DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0740 TORQUE CONVERTER (Torque Converter Clutch Circuit/Open) Diagnosis condition When all of the following conditions are satisfied: TCM power supply voltage: More than 11 V P0743 is not detected Signal — Threshold TCM judges that solenoid valve circuit is open Diagnosis delay time Maintained for 5 seconds POSSIBLE CAUSE Harness or connector (Torque converter clutch solenoid valve circuit is open or shorted to power supply) Torque converter clutch solenoid valve FAIL-SAFE Start is slow Acceleration is slow Lock-up is not performed DTC Confirmation Procedure CAUTION: Be careful of the driving speed...

Nissan Murano (Z52) 2015-2024 Service Manual: Engine Mount. Engine Mount (front)

Removal and Installation WARNING: Situate the vehicle on a flat and solid surface. Place chocks at front and back of rear wheels. CAUTION: Always work safely. Do not start work until the engine and exhaust system are cooled completely. Refer to the applicable sections for warnings, cautions, notes, and instructions if necessary procedures are not included in this section...