Nissan Murano: Exterior :: Removal and Installation / Roof Side Molding

Nissan Murano (Z52) 2015-2024 Service Manual / Body Exterior, Doors, Roof & Vehicle Security / Exterior :: Removal and Installation / Roof Side Molding

Exploded View

Roof side molding

Metal clips

Removal and Installation

REMOVAL

Beginning at the front of the vehicle, release roof side molding (1) metal clips using a suitable tool (A) then remove.

: Metal clip

CAUTION:

Apply protective tape (B) around the roof side molding.

INSTALLATION

Installation is in the reverse order of removal.

Rear Under Cover

Removal and Installation REMOVALRemove the rear under cover screws. Remove the rear under cover.INSTALLATIONInstallation is in the reverse order of removal...

Roof Side Rail

Exploded View 1. Roof rack bolt cover 2. Roof rack 3. Roof rack bracket 4. End cap Metal clip Removal and Installation NOTE: Begin removal procedure at the front of the Nissan Murano vehicle...

Other information:

Nissan Murano (Z52) 2015-2024 Owners Manual: AEB with Pedestrian Detection system limitations

WARNING Listed below are the system limitations for the AEB with Pedestrian Detection system. Failure to operate the vehicle in accordance with these system limitations could result in serious injury or death. The AEB with Pedestrian Detection system cannot detect all vehicles or pedestrians under all conditions...

Nissan Murano (Z52) 2015-2024 Service Manual: System Settings Cannot Be Turned On/off on the Integral Switch

Symptom Table CAUTION: Perform the “Self Diagnostic Result” with CONSULT before the symptom diagnosis. Perform the trouble diagnosis if any DTC is detected. Symptom Inspection item/Reference page AEB system does not turn ON/OFF AEB warning lamp is not turned ON⇔OFF when operating integral switch Diagnosis Procedure Diagnosis Procedure AEB system does not turn ON/OFF...