Nissan Murano: Wiper & Washer :: Removal and Installation / Rear Wiper Motor
Exploded View

| 1. |
Seal |
2. |
Rear wiper motor |
A. |
Refer to Installation. |
Removal and Installation
REMOVAL
Remove the rear wiper arm. Refer to Removal and Installation.
Remove the back door lower finisher. Refer to Removal and Installation.
Disconnect the harness connector from the rear wiper motor.
Remove the rear wiper motor bolts.
Remove the rear wiper motor.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
Tighten the rear wiper motor bolts to specification in the sequence shown.

| Washer motor bolts |
: 5.5 N·m (0.56 kg-m, 49 in-lb) |
Exploded View
1.
Rear wiper arm cover
2.
Seal
3.
Rear wiper arm assembly
4.
Rear wiper blade
Removal and Installation
REMOVALOperate the rear wiper arm into the auto stop position...
Other information:
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
U0104-82
ADAS CAN CIR1
(ADAS control unit CAN circuit 1)
Diagnosis condition
When ignition switch is ON.
Signal (terminal)
–
Threshold
Side radar detected an error of ITS communication signal that was received from ADAS control unit
Diagnosis delay time
–
POSSIBLE CAUSE
ADAS control unit
Side radar LH
FAIL-SAFEThe following systems are canceled:
Blind Spot Warning (BSW)
Rear Cross Traffic Alert (RCTA)
DTC Confirmation Procedure
CHECK DTC PRIORITY
If DTC “U0104-82” is displayed with DTC “U1000-01”, first diagnose the DTC “U1000-01”...
..
Categories

Your vehicle has two types of security systems:
Vehicle security system
NISSAN Vehicle Immobilizer System
The vehicle security system provides visual
and audible alarm signals if someone
opens the doors, liftgate or the hood when
the system is armed. It is not, however, a
motion detection type system that activates
when a vehicle is moved or when a
vibration occurs.
read more