Nissan Murano: Fender Protector / Rear Wheel House Protector
| 1. | Rear wheel house protector | 2. | Rear over fender |  |
Clip |
 |
Front |
REMOVAL
Remove rear over fender. Refer to Removal and Installation.
Remove rear wheel house protector clips.
Remove rear wheel house protector nuts and rear wheel house protector.
INSTALLATION
Installation is in the reverse order of removal.
Fender Protector
Exploded View
1.
Front fender protector
2.
Engine side cover
3.
Front over fender
Clip
Front
Removal and Installation
REMOVALPosition the front wheels as necessary to remove screws and clips...
Over Fender
..
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: Automatic Back Door Warning Does Not Operate. Buzzer
Diagnosis Procedure Automatic back door warning buzzer does not operate when automatic back door warning function is performed.CHECK DTC WITH AUTOMATIC BACK DOOR CONTROL MODULE Check that DTC is not detected with automatic back door control module. Is the inspection result normal? YES>> GO TO 2...
Nissan Murano (Z52) 2015-2024 Owners Manual: Conditions the Remote Engine Start will notwork
The Remote Engine Start will not operate if any of the following conditions are present: The ignition switch is placed in the ON position. The hood is not securely closed. The hazard indicator lights are on. The engine is still running. The engine must be completely stopped...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- System malfunction
- Tire rotation
- Turning the AEB system on/off
- New on site
- Most important about car
LATCH (Lower Anchors and Tethers for CHildren) system
LATCH system lower anchor locations - bench seat
Your vehicle is equipped with special anchor points that are used with LATCH system compatible child restraints. This system may also be referred to as the ISOFIX or ISOFIX compatible system. With this system, you do not have to use a vehicle seat belt to secure the child restraint unless the combined weight of the child and child restraint exceeds 65 lbs. (29.5 kg). If the combined weight of the child and child restraint is greater than 65 lbs. (29.5 kg), use the vehicle’s seat belt (not the lower anchors) to install the child restraint. Be sure to follow the child restraint manufacturer’s instructions for installation.
