Nissan Murano: Exterior :: Removal and Installation / Fender Protector

Cowl Top

Exploded View 1. Cowl top cover seal 2. Cowl top side trim cover (RH) 3. Cowl top cover 4. Cowl top extension 5. Cowl top side trim cover (LH) A...

Fender Protector

Exploded View 1. Front fender protector 2. Engine side cover 3. Front over fender Clip Front Removal and Installation REMOVALPosition the front wheels as necessary to remove screws and clips...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Side Radar

Exploded View 1. Side radar 2. Rear fender Front NOTE: LH shown, RH similar. Removal and Installation REMOVALRemove the rear bumper fascia. Refer to Removal and Installation. Disconnect the harness connector from side radar. Remove the nuts and remove the side radar...

Nissan Murano (Z52) 2015-2024 Service Manual: P2100 Throttle Control Motor Relay

DTC Description DTC DETECTION LOGIC ECM detects that the voltage of power source for throttle control motor is excessively low. ECM detects that the throttle control motor relay is stuck ON. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P2100 ETC MOT PWR-B1 (Throttle actuator “A” control motor circuit/open) Diagnosis condition Start engine and let it idle Signal (terminal) Throttle control motor circuit Threshold ECM detects that the voltage of power source for throttle control motor is excessively low Diagnosis delay time — P2103 ETC MOT PWR-B1 (Throttle actuator “A” control motor circuit high) Diagnosis condition Ignition switch ON Signal (terminal) Throttle control motor circuit Threshold ECM detects that the throttle control motor relay is stuck ON Diagnosis delay time — POSSIBLE CAUSEDTC P2100 Harness or connectors (Throttle control motor relay circuit is open) Throttle control motor relay DTC P2103 Harness or connectors (Throttle control motor relay circuit is shorted) Throttle control motor relay FAIL-SAFE Engine operating condition in fail-safe mode Fail safe mode Nissan Murano Vehicle behavior Throttle control motor relay ECM stops the electric throttle control actuator control, throttle valve is maintained at a fixed opening (approx...