Nissan Murano: Rear Cross Traffic Alert (RCTA) (if so equipped) / How to enable/disable the RCTA system
Perform the following steps to enable or disable the RCTA system.
Using “Settings” in the vehicle information display:
- Press the
button until
“Settings”
displays in the vehicle information display
and then press the OK button. Use
the 
button to select “Driver
Assistance.”
Then press the OK button. - Select “Blind Spot” and press the OK button.
When the RCTA system is turned on, the BSW/RCTA indicator (white) in the vehicle information display illuminates.
Using the “Driving Aids” screen in the vehicle information display:
Use the 
buttons on the steering
wheel to scroll to the Driving Aids
screen.
Press the OK button to access the Driver Assistance menu.
Select “Blind Spot” and press OK to change the LSD3432 Driving Aids setting.
NOTE:
The RCTA system is integrated into the BSW system. There is not a separate selection in the vehicle information display for the RCTA system. When the BSW is disabled, the RCTA system is also disabled.
When enabling/disabling the system, the system setting will be retained even if the engine is restarted.
RCTA system operation
Side BSW/RCTA Indicator Light
BSW/RCTA Indicator
The RCTA system can help alert the driver
of an approaching vehicle when the driver
is backing out of a parking space...
RCTA system limitations
WARNING
Listed below are the system limitations
for the RCTA system. Failure to operate
the vehicle in accordance with these
system limitations could result in serious
injury or death...
Other information:
Nissan Murano (Z52) 2015-2024 Service Manual: System Settings Cannot Be Turned On/off on the Integral Switch
Symptom Table CAUTION: Perform the “Self Diagnostic Result” with CONSULT before the symptom diagnosis. Perform the trouble diagnosis if any DTC is detected. Symptom Inspection item/Reference page AEB system does not turn ON/OFF AEB warning lamp is not turned ON⇔OFF when operating integral switch Diagnosis Procedure Diagnosis Procedure AEB system does not turn ON/OFF...
Nissan Murano (Z52) 2015-2024 Service Manual: Door Does Not Lock/unlock and Engine Does Not Start (all I-Key/req Sw/push Sw)
Diagnosis Procedure All doors do not lock/unlock using door request switch or back door does not open using back door opener request switch, Intelligent Key, and engine does not start when ignition switch is pressed while carrying Intelligent Key.SYMPTOM TABLE (BOTH INTELLIGENT KEYS HAVE THE SAME SYMPTOMS) Door lock operation (remote keyless entry) Door lock operation (request switch) or back door open operation (opener switch of back door panel) Engine started with ignition switch operation (registered Intelligent Key is within the detection area of inside key antenna) Engine started with ignition switch operation (registered Intelligent Key placed next to ignition switch) NG NG No crank, No start OK CONDITIONS OF VEHICLE (OPERATING CONDITIONS)“ENGINE START BY I-KEY” setting in “Work support” mode of “BCM(INTELLIGENT KEY)” is ON...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- Power Steering Fluid (PSF)
- How to enable/disable the LDW system
- Vehicle Dynamic Control (VDC) OFF switch
- New on site
- Most important about car
Autolight system
The autolight system allows the headlights to turn on and off automatically. The autolight system can:
Turn on the headlights, front parking, tail, license plate and instrument panel lights automatically when it is dark. Turn off all the lights (except daylight running lights) when it is light. Keep all the lights on for a period of time after you place the ignition switch in the OFF position and all doors are closed.