Nissan Murano: Ducts and Grilles / Rear Center Ventilator Duct
Removal and Installation
REMOVAL
Remove the center console rear finisher. Refer to Exploded View.
Remove the clip and rear center ventilator duct.
INSTALLATION
Installation is in the reverse order of removal.
Removal and Installation - Front Floor Connecting Duct
REMOVALRemove the center console side finisher. Refer to Exploded View.
Remove the front floor connecting duct...
Removal and Installation - Center Floor Duct
REMOVALRemove the center console assembly. Refer to Exploded View.
Remove the steering member brace (LH). Refer to Exploded View...
Other information:
The heated steering wheel system is designed
to operate only when the surface
temperature of the steering wheel is below
68°F (20°C).
Push the heated steering wheel switch to
warm the steering wheel after the ignition
switch is placed in the ON position...
Work Procedure
CAUTION:
Never use compressed air or a high pressure pump.
Never exceed 4.12 kPa (0.042 kg/cm2, 0.6 psi) of pressure in EVAP system.
NOTE:
Do not start engine.
Improper installation of EVAP service port adapter (commercial service tool) to the EVAP service port may cause a leakage...
Categories

LATCH system lower anchor locations -
bench seat
Your vehicle is equipped with special anchor
points that are used with LATCH system
compatible child restraints. This system
may also be referred to as the ISOFIX
or ISOFIX compatible system. With this system,
you do not have to use a vehicle seat
belt to secure the child restraint unless the
combined weight of the child and child restraint
exceeds 65 lbs. (29.5 kg). If the combined
weight of the child and child restraint
is greater than 65 lbs. (29.5 kg), use the vehicle’s
seat belt (not the lower anchors) to
install the child restraint. Be sure to follow
the child restraint manufacturer’s instructions
for installation.
read more