Nissan Murano: Ducts and Grilles / Front Floor Duct
Removal and Installation - Front Floor Connecting Duct
REMOVAL
Remove the center console side finisher. Refer to Exploded View.
Remove the front floor connecting duct.
INSTALLATION
Installation is in the reverse order of removal.
Removal and Installation - Front Floor Duct
REMOVAL
Remove the front floor connecting duct. Refer to Removal and Installation - Front Floor Connecting Duct.
Remove the floor trim. Refer to Removal and Installation.
Remove the screw and the front floor duct.
INSTALLATION
Installation is in the reverse order of removal.
Removal and Installation
REMOVALRemove the side defroster ducts (LH/RH). Refer to Removal and Installation.
Remove the screws and defroster nozzle.INSTALLATIONInstallation is in the reverse order of removal...
Removal and Installation
REMOVALRemove the center console rear finisher. Refer to Exploded View.
Remove the clip and rear center ventilator duct.INSTALLATIONInstallation is in the reverse order of removal...
Other information:
Component Function Check
CHECK POWER WINDOW SWITCH OUTPUT SIGNAL
CONSULT
Select “CDL LOCK SW ” or “CDL UNLOCK SW” in “Data Monitor” mode of “BCM(DOOR LOCK)”. Refer to CONSULT Function (BCM - DOOR LOCK).
Monitor item Condition
CDL LOCK SW
LOCK
: ON
UNLOCK
: OFF
CDL UNLOCK SW
LOCK
: OFF
UNLOCK
: ON
Is the inspection result normal?
YES>>
Power window serial link is OK...
Diagnosis Procedure
CHECK HARNESS CONTINUITY (OPEN CIRCUIT)
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Disconnect the following harness connectors.
ECM
IPDM E/R
ABS actuator and electric unit (control unit)
Check the continuity between the IPDM E/R harness connector and the ABS actuator and electric unit (control unit) harness connector...