Nissan Murano: Exterior :: Removal and Installation / Quarter Glass Molding

Nissan Murano (Z52) 2015-2024 Service Manual / Body Exterior, Doors, Roof & Vehicle Security / Exterior :: Removal and Installation / Quarter Glass Molding

Exploded View

Quarter glass molding

Clip

Removal and Installation

REMOVAL

CAUTION:

Disengage the clips slowly and carefully.

Release quarter glass molding clips, using suitable tool.

Remove quarter glass molding from Nissan Murano vehicle.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:

When installing, visually check the quarter glass molding and the clips and replace them with new parts if they have been damaged.

When installing the quarter glass molding, check that clips are securely fitted in panel holes on body, and then press them in.

Door Outside Lower Molding

Exploded View 1. Front door outside lower molding 2. Rear door outside lower molding Clip Removal and Installation FRONT DOOR OUTSIDE LOWER MOLDINGRemovalUsing a suitable tool (A), release clips from front door outside lower molding (1) starting at the rear and working forward...

Rear Spoiler

Exploded View 1. Rear spoiler 2. Rear washer nozzle 3. High-mounted stop lamp Removal and Installation REMOVALRemove side air spoiler. Refer to Removal and Installation...

Other information:

Nissan Murano (Z52) 2015-2024 Owners Manual: BSW system limitations

WARNING Listed below are the system limitations for the BSW system. Failure to operate the vehicle in accordance with these system limitations could result in serious injury or death. The BSWsystem cannot detect all vehicles under all conditions...

Nissan Murano (Z52) 2015-2024 Owners Manual: System maintenance

The radar sensor is located on the front of the vehicle . The camera is located on the upper side of the windshield . To keep the AEB with Pedestrian Detection system operating properly, be sure to observe the following: Always keep the sensor areas of the front bumper and windshield clean...