Nissan Murano: Exterior :: Removal and Installation / Rear Spoiler

Nissan Murano (Z52) 2015-2024 Service Manual / Body Exterior, Doors, Roof & Vehicle Security / Exterior :: Removal and Installation / Rear Spoiler

Exploded View

Rear spoiler

Rear washer nozzle

High-mounted stop lamp

Removal and Installation

REMOVAL

Remove side air spoiler. Refer to Removal and Installation.

Remove back door side finishers. Refer to Removal and Installation.

Disconnect the rear washer tube.

Disconnect the harness from the high-mounted stop light.

Remove nuts and bolts and remove spoiler.

INSTALLATION

Installation is in the reverse order of removal.

Quarter Glass Molding

Exploded View 1. Quarter glass molding Clip Removal and Installation REMOVALCAUTION: Disengage the clips slowly and carefully. Release quarter glass molding clips, using suitable tool...

Side Air Spoiler

Exploded View 1. Rear spoiler 2. Side air spoiler Clip Removal and Installation REMOVALRemove luggage side upper finisher. Refer to Removal and Installation...

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Power Consumption Control System

System Description SYSTEM DIAGRAMINPUT SIGNAL AND OUTPUT SIGNALMajor signal transmission between each unit via communication lines is shown in the following table: Component parts Signal description IPDM E/R Each unit transmits the sleep-ready signal (ready) to BCM when all of the CAN sleep conditions are fulfilled...

Nissan Murano (Z52) 2015-2024 Service Manual: Tcs Function

System Description SYSTEM DIAGRAM Wheel spin status of drive wheel is detected by wheel sensor of 4 wheels. Engine output and transmission shift status are controlled so that slip rate of drive wheels is in appropriate level. When wheel spin occurs on drive wheel, ABS actuator and electric unit (control unit) performs brake force control of LH and RH drive wheels (applies brake force by increasing brake fluid pressure of drive wheel) and decreases engine torque by engine torque control...