Nissan Murano: Body Exterior, Doors, Roof & Vehicle Security / Power Window Control System :: Ecu Diagnosis Information

System

System Description SYSTEM DIAGRAMINPUT/OUTPUT SIGNAL CHART Item Input signal to main power window and door lock/unlock switch Main power window and door lock/unlock switch function Actuator Encoder Encoder pulse signal Power window control Front power window motor Main power window and door lock/unlock switch Front power window motor LH UP/DOWN signal Power window and door lock/unlock switch RH Front power window motor RH UP/DOWN signal BCM RAP signal Rear power window switch Rear power window motor UP/DOWN signal Rear power window motor POWER WINDOW OPERATION Power window system is activated by the power window switches when ignition switch ON position or during the retained power operation after ignition switch OFF...

Bcm (body Control Module)

L..

Other information:

Nissan Murano (Z52) 2015-2024 Service Manual: Front Wheel Drive

Removal and Installation - FWD RemovalWARNING: Do not remove the radiator cap when the engine is hot. Serious burns could occur from high pressure engine coolant escaping from the radiator. Wrap a thick cloth around the cap. Slowly turn it a quarter turn to allow built-up pressure to escape...

Nissan Murano (Z52) 2015-2024 Service Manual: P0603 Ecm

DTC Description DTC DETECTION LOGIC ECM back up system does not function properly. EEPROM (built-in microcomputer) system internal ECM does not function properly. DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0603 ECM BACK UP/CIRCUIT [Internal Control Module Keep Alive Memory (KAM) Error] Diagnosis condition Ignition switch ON Signal (terminal) — Threshold ECM back up system does not function properly Diagnosis delay time — P062F CONTROL MODULE (Internal control module EEPROM error) Diagnosis condition Start engine and let it idle Signal (terminal) — Threshold EEPROM (built-in microcomputer) system internal ECM does not function properly Diagnosis delay time — POSSIBLE CAUSEDTC P0603 Harness or connectors [ECM power supply circuit is open or shorted...