Nissan Murano: Automatic Drive Positioner :: Removal and Installation / Power Seat Switch
Removal and Installation
REMOVAL
Remove seat cushion outer finisher (LH) (2). Refer to Seat Cushion.

Remove the power seat switch screws (A).
: Front
Remove power seat switch (1) from seat cushion outer finisher (LH) (2).
INSTALLATION
Installation is in the reverse order of removal.
Removal and Installation
REMOVALRemove front door finisher (LH). Refer to Removal and Installation.
Release the pawls using a suitable tool (A) and remove seat memory switch (2) from switch finisher (1)...
Removal and Installation
REMOVALRemove steering column covers. Refer to Removal and Installation.
Release the pawls and remove ADP steering switch (2) from the steering column lower cover (1)...
Other information:
Fill the windshield-washer fluid reservoir periodically.
Add windshield-washer fluid when
the “Low Washer Fluid” warning message
shows on the vehicle information display.
To fill the windshield-washer fluid reservoir,
lift the cap off the reservoir and pour the
windshield-washer fluid into the reservoir
opening...
Values on the Diagnosis Tool
VALUE ON THE DIAGNOSIS TOOLNOTE:
The following table includes information (items) inapplicable to this Nissan Murano vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items.
Monitor item Condition Value/Status
CAMERA HIGH TEMP
When the temperature around lane camera unit is adequate
NORMAL
When the temperate around the lane camera unit is high
HIGH
WIPER
Ignition switch ON
Wiper position is High
Hi
Wiper position is Low
Lo
Wiper position is OFF
Off
TURN SIGNAL
Turn signal lamp LH and RH blinking
LH&RH
Turn signal lamp LH blinking
LH
Turn signal lamp RH blinking
RH
Turn signal lamps OFF
Off
Nissan Murano Vehicle SPEED
While drive
km/h
DRIVER ASSIST SYSTEM SET
NOTE:
The item is displayed, but it is not used...