Nissan Murano: Driveline :: Rear Final Drive: R145 / Periodic Maintenance. Rear Differential Gear Oil
OIL LEAKAGE
Make sure that oil is not leaking from final drive assembly or around it.
OIL LEVEL
Check oil level from filler plug mounting hole as shown in the figure after removing filler plug (1) and gasket from final drive assembly.
CAUTION:
Turn the ignition switch OFF while checking oil level.
-
Oil level should be level with bottom of filler plug mounting hole. Add gear oil if necessary. Refer to Refilling.
Set a gasket on filler plug and install it on final drive assembly.
CAUTION:
Do not reuse gasket.
Tighten filler plug to the specified torque. Refer to Exploded View.
Turn the ignition switch OFF.
Remove drain plug (1) and gasket.
Drain gear oil.
Set a gasket on drain plug and install it to final drive assembly.
CAUTION:
Do not reuse gasket.
Tighten drain plug to the specified torque. Refer to Exploded View.
Remove filler plug and gasket (1). Then fill with new gear oil until oil level reaches the specified level near filler plug mounting hole.
| Recommended oil and capacity | : Refer to Fluids and Lubricants. |
Set a gasket on filler plug, and install it to final drive assembly.
CAUTION:
Do not reuse gasket.
Tighten filler plug to the specified torque. Refer to Exploded View.
Other information:
Nissan Murano (Z52) 2015-2024 Owners Manual: Hazard warning flasher switch
Push the switch on to warn other drivers when you must stop or park under emergency conditions. All turn signal lights flash. WARNING If stopping for an emergency, be sure to move the vehicle well off the road. Do not use the hazardwarning flashers while moving on the highway unless unusual circumstances force you to drive so slowly that your vehicle might become a hazard to other traffic...
Nissan Murano (Z52) 2015-2024 Service Manual: C1201 Controller Failure
DTC Description DTC DETECTION LOGICMalfunction has occurred inside AWD control unit. DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition C1201 CONTROLLER FAILURE (Control unit failure) Diagnosis condition Ignition switch: ON Signal — Threshold — Diagnosis delay time — POSSIBLE CAUSEInternal malfunction of AWD control unitFAIL-SAFEFront-wheel drive or shifts to 4-wheel drive (rear-wheels still have some driving torque)...
Categories
- Manuals Home
- Nissan Murano Owners Manual
- Nissan Murano Service Manual
- How to enable/disable the LDW system
- Indicator lights
- Shift lock release
- New on site
- Most important about car
Luggage hooks
When securing items using luggage hooks located on the back of the seat or side finisher do not apply a load over more than 6.5 lbs. (29 N) to a single hook.
The luggage hooks that are located on the floor should have loads less than 110 lbs. (490 N) to a single hook.
