Nissan Murano: Do-it-yourself / Fuses
If any electrical equipment does not operate,
check for an open fuse.
Fuses are used in the passenger and engine
compartment. Spare fuses are provided
and can be found in the passenger
compartment fuse box.
When installing a fusemake sure the fuse is
installed in the fuse box securely.
If the brakes do not operate properly, have
the brakes checked. It is recommended
that you visit a NISSAN dealer for this service.
Self-adjusting brakes
Your vehicle is equipped with self-adjusting
brakes...
WARNING
Never use a fuse of higher or lower amperage
rating than that specified on the
fuse box cover. This could damage the
electrical system or electronic control
units or cause a fire...
Other information:
Condition A:
The warning and assist functions of the I-LI
system are not designed to work under the
following conditions:
When you operate the lane change signal
and change the traveling lanes in
the direction of the signal. (The I-LI system
will be deactivated for approximately
2 seconds after the lane change
signal is turned off...
Push brake and start switch to drive
No Key Detected
Shift to Park
Key Battery Low
Engine start operation for Intelligent Key system (if I-Key battery
level is low)
Key ID Incorrect
Release Parking Brake
Low Fuel
Low Washer Fluid
Door/liftgate Open
Key System Fault See Owner’s Manual
Loose Fuel Cap
Tire Pressure Low – Add Air
AWD Error: See Owner’s Manual (if so equipped)
AWD High Temp...